Download Print this page

Starizona Cool Edge Quick Manual

Sct cooler- 14" celestron

The Cool Edge allows for rapid thermal stabilization of the air and optics inside your Celestron Fastar-

compatible telescope. By moving filtered air through the optical tube, distorting tube currents and heat

spikes are eliminated.

Included Items

• Cool Edge SCT Cooler

• AC or DC Adapter (user selected)

Above: Cool Edge for 14" Telescope

No tools are necessary for the installation and use of the Cool Edge

Table of Contents

Do you have a question about the Cool Edge and is the answer not in the manual?

Page 1 The Cool Edge allows for rapid thermal stabilization of the air and optics inside your Celestron Fastar- compatible telescope. By moving filtered air through the optical tube, distorting tube currents and heat spikes are eliminated. Included Items • Cool Edge SCT Cooler •...
Page 2 Placing the Mirror in the Cool Edge Note the position of the notch in the top threaded ring of the Cool Edge and the matching set screw in the side of the secondary mirror housing. Carefully set the mirror into the Cool Edge with the set screw...
Page 3 Thread the retaining ring from the telescope onto the Cool Edge to hold the mirror in place. Do not over-tighten this ring as temperature changes can make it difficult to remove. Attaching the Cool Edge to the Telescope Thread the entire Cool Edge assembly onto the front of the telescope. Again, do not over-tighten the cooler to avoid it being difficult to remove later.
Page 4 Powering Up the Cool Edge There is no power switch on the Cool Edge—simply plug it in using the included power supply and it will begin running. We recommend letting the cooler run for at least 10 minutes to stabilize the telescope.