Power Connections - Martin M1 Safety And Installation Instructions Manual

Power Connections

Martin M1 is rated 100-240V 50/60Hz, operates over 90-264V 50/60Hz. Do not connect it to
power outside this range.
The provided IEC cable is not fitted with a country-specific plug.
Please install a plug that meets local and national electric codes and is suitable for the country's
specific power outlet types.
A 3-prong grounding-type plug must be installed following the plug manufacturer's instructions. The
table below shows some possible pin identification schemes; if the pins are not clearly identified, or if
you have any doubts about proper installation, consult a qualified electrician.
A cable with a NEMA 15-5P plug is provided for use of the M1 in the US and Canada. The approved
cable must be used in North America.
Wire color (standard EU code)
brown
blue
yellow/green
1. Check the Power Switch and ensure that is set to the OFF position.
2. Insert the provided power cable into the MAINS IN connector and connect the cable to a properly
protected and grounded power outlet.
3. Turn on the M1 by toggling the power switch to ON.
In addition to the IEC inlet the M1 also provides a IEC outlet port to connect a monitor or a
MaxModule device.
Do not exceed a current-draw of 4A on the IEC outlet port.
Martin M1 Safety and Installation Guide
Pin
live
neutral
ground
8
Symbol
L
N
© 2010 Martin Professional A/S