Bandwidth Control; Ip& Mac Binding - Binatone WR1500N User Manual

4.11 Bandwidth Control

You can configure the Bandwidth control function on this page shown in Figure 4-40:
Enable IP QoS - Enable or disable the function of IP QoS.

Choose BandWidth Type - Select the network connection type from the drop-down list.

Bandwidth Apply - The bandwidth you get. If you are not clear about that, please contact

with your ISP for help.
IP Range - IP range of this entry.

Mode - There are two types of mode: Minimum Bandwidth Guarantee and Maximum

Bandwidth Limit.
Bandwidth - The bandwidth you supply to this entry.

Description - The description for this entry.

Click Enable to enable this entry.
Click the Clear button to clear a single entry.
Click the Clear All button to clear all entries.
Click the Save button to save all configurations.

Note:
1. The conversion relation of bandwidth: 1Mbps = 1024Kbps.
2. Please choose the Network Connection Type and set the bandwidth according to your
Network. If you are not clear about that, please contact with your ISP for help.
3. If no IP QoS item is enabled, the Bandwidth Apply won't be effective.
4. IP address range for different entries could not have intersection with each other.
5. After the configurations, click the Save button for the change to take effect.
4.12 IP& MAC Binding
Figure 4-41 the IP & MAC Binding menu
WR1500N
Figure 4-40 Bandwidth Control
- 45 -
150Mbps Wireless N Router