Turning On The Appliance - Prima LPR661 Instruction Manual

Turning on the Appliance

Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1
push them back. It is commended that loading the lower
basket first, than the upper one (see the section entitled
"Loading the Dishwasher").
2
Pour in the detergent (see the section entitled "Sal t,
Detergent and Rinse Aid").
3 Insert the plug into the socket. The power supply is 220-240
VAC 50 Hz, the specification of the socket is 10 A 250 VAC.
Make sure that the water supply is turned on to full pressure.
Open the door,press the ON/OFF button,and the ON/OFF light will turn
4
on.
Pre ss the "prog. "Button to select a desired "Wash cycle".(see
the section entitled."Wash Cycle Table".)
5 With a little force to ensure the door i s properly closed.
NOTE: A click could be heard when the door is closed perfectly.
When the washing is over, you can shut off the switch by
6
pressing ON/OFF button.
Premise: A cycle that is underway can only be modified if it
has only been running for a short time. Otherwise, the detergent
may have already been released, and the appliance may have
already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
Open the door,Press current prog. Button more than three
seconds to cancel the program ,then you can change the
program to the desired cycle setting (see the section entitled
" Starting a wash cycle. . . " ). Then, close the door.
NOTE: If you open the door when washing, the machine
will pause. When you close the door , the machi ne will
keep on working after 10 seconds.
NOTE:
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling a service.
A forgotten dish can be added at any time before the detergent cup opens.
1
Open the door a little to stop the washing.
2
After the spray arms stop working, you can open the door
completely.
It is dangerous to open the door when washing,because the hot water may scald you.
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handl ing the di shes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
3
Load the forgotten dishes.
4
Close the door, the dishwasher will start running again
after 10 seconds.
15
PROG .