Advertisement
IF THE MATERIAL DOES NOT FEED PROPERLY, CHECK FOR:
• excess clogging in the dust hood.
• excess oil/debris/pitch on feed rollers.
• excessively twisted, cupped or bowed material.
• a broken drive belt.
• dull knives.
IF THE CIRCUIT BREAKER TRIPS REPEATEDLY:
• check the sharpness of the knives.
NOTE: Circuit breaker overload is often the result of dull knives. If the circuit breaker on your planer trips, check the sharpness of your knives before attempting
to reset the breaker in order to continue planing.
• reduce the depth of cut.
IF THE UNIT DOES NOT RUN, CHECK TO SEE:
• if the unit is plugged in.
• if the tool tray is properly in place.
• if the circuit breaker needs to be reset.
TROUBLESHOOTING GUIDE
7
Advertisement
