Table of Contents
Advertisement
6
Mini Portable Reader User Manual
2. Mini Portable Reader Basics
2.1 Preparing For Operation
1)
Remove the Mini Portable Reader from the shipping package.
2)
Turn the Mini Portable Reader ON by pressing the ON/OFF button
located on the keypad.
The Mini Portable Reader shuts down automatically when left unused for one
minute. This feature prolongs the life of the batteries. (The reader will "Beep" twice
before shutting itself off.) The reader will have a reduced read range when the
battery level drops below approximately 25 percent. The reader may be shut OFF
manually by pressing the ON/OFF button.
2.2 Scanning With The Mini Portable Reader
When you first turn on your Mini Portable Reader it will be in the "Tag Read Mode"
and will display the following message:
Where "nn" will be a two digit number representing the file into which you will store
ID numbers when the STORE capability is turned on. If the STORE capability is
not turned on the display will be:
TO SCAN FOR AN ID TAG:
1) Hold down the
2) When a tag is read, the Mini Portable Reader will beep (if the BEEPER is
turned on - see Section 7), and display the number:
Example: (With STORE turned OFF)
Example: (With STORE turned ON)
3) If no ID code is read, the LCD display message will be:
4) To scan successive ID codes - simply press the
READY
READ
button until you have read a tag ID code.
(The "004" indicates that this is the 4th code to be stored in the file.)
READY
nn
-- --
221967254B
221967254B
READ
004
NO ID FOUND
button again.
Advertisement
Table of Contents
