Dodge Intrepid Service Manual page 801

23 - 64 INTERIOR
CENTER CONSOLE BEZEL
REMOVAL
NOTE: The Transmission Range Indicator Lamp
(electroluminescent) is not serviceable. Replace
Floor Console Panel for replacement of the lamp.
(1) Set park brake and place gear selector in neu-
tral.
(2) Remove instrument panel center bezel. (Refer
to 23 - BODY/INSTRUMENT PANEL/INSTRUMENT
PANEL CENTER BEZEL - REMOVAL)
(3) Loosen set screw attaching gear shift knob to
gear shift.
(4) Remove gear shift knob from gear shift.
(5) Disengage clips attaching bezel to floor console
(Fig. 7), or (Fig. 8).
(6) Disconnect the power outlet, if equipped.
(7) Disconnect the transmission range indicator
illumination connector.
(8) Remove bezel from vehicle.
INSTALLATION
(1) Connect the transmission range indicator illu-
mination connector.
(2) Connect power outlet, if equipped.
(3) Place bezel in position on vehicle.
(4) Engage clips attaching bezel to floor console.
1 - INSTRUMENT PANEL
2 - FLOOR CONSOLE SHIFT BEZEL
3 - TRANSMISSION RANGE INDICATOR ILLUMINATION
CONNECTORS
Fig. 7 FLOOR CONSOLE BEZEL - CONCORDE
Fig. 8 FRONT FLOOR CONSOLE SIDE PANELS -
INTREPID SHOWN - 300M SIMILAR
1 - INSTRUMENT PANEL
2 - FLOOR CONSOLE BEZEL
3 - POWER OUTLET/CIGAR LIGHTER CONNECTORS
4 - TRANSMISSION RANGE INDICATOR ILLUMINATION
CONNECTORS
5 - REAR END CAP
6 - FLOOR CONSOLE
7 - FRONT FLOOR CONSOLE PANEL
4 - REAR BEZEL
5 - FLOOR CONSOLE
LH