Controls And Indicators - Club Car Villager 6 Owner's Manual

Controls and Indicators

1
4
CC5819-123456
BC54679
ASSEMBLED IN USA
2843
Figure 6 Serial Number Decal
CONTROLS AND INDICATORS
See General Warnings on page 11.
WARNING
• Before allowing anyone to drive the vehicle, make sure the driver is familiar with all controls and
operating procedures.
• Gasoline vehicles only: Do not tamper with the governor. Doing so will void the warranty, as well as
damage the engine and other components, and can result in property damage, personal injury, or
death due to unsafe speeds.
KEY SWITCH
The key switch (1) is mounted on the dash to the right of the steering column (Figure 8 or Figure 7).
Each vehicle is equipped with either a two-position key switch or a three-position key switch. All electric vehicles are
equipped with a two-position key switch. Gasoline vehicles equipped with a three-position key switch are referred to as
"key-start".
• Electric vehicles: The key switch has two positions: OFF and ON.
• Key-start vehicles: The key switch has three positions: OFF, ON and START. To start the vehicle, turn the key
past the ON position to the START position and hold until the engine is running smoothly. Release the key and it will
return to the ON position and the engine should idle.
WARNING
• Moving parts! Keep clear of the engine compartment while the engine is running.
CAUTION
• Key-start vehicles: Do not "rev" the engine for long periods of time while the Forward/Reverse handle
is in the NEUTRAL position. Failure to heed this caution can result in damage to the transaxle.
• Key-start vehicles: Do not shift the Forward/Reverse handle while the accelerator pedal is pressed.
Shift the handle only when the vehicle is at a complete stop and the engine is at idle. Failure to heed
this caution can result in damage to the transaxle.
Page 16 Villager 6 and 8 Owner's Manual
2 3
SERIAL NUMBER