G015693
1. Inlet plug
2. Extension cord
Starting the Trimmer
To start the trimmer, slide the lock switch back to the On position,
then squeeze the trigger (Figure 6).
G015658
1. Lock switch
Stopping the Trimmer
To stop the trimmer, release the trigger.
Advancing the Line
Note: The trimmer is equipped with an auto-feed head.
1. With the trimmer running, release the switch trigger.
2. Wait 2 seconds, then press the switch trigger.
Note: The line will extend approximately 6 mm (1/4 inch)
with each stop and start of the switch trimmer until the line
reaches the length of the grass deflector blade.
3. Resume trimming.
3
2
Figure 6
3. Cord lock
1
2
Figure 7
2. Trigger
Advancing the Line Manually
Disconnect the string trimmer from the power supply, then push
the red button at the base of the spool retainer while pulling on the
trimmer line to manually advance the line.
Trimming
1
Edging
To convert the trimmer to an edger, press the rotator button and
rotate the head as shown in Figure 9.
1
1. Rotator button
6
Figure 8
2
G015660
Figure 9
2. Edger guide