HP 7414A Operating And Service Manual page 3

r
r
,
(
",MANUAL CHANGES
MODEL
7414A
THERMAL-TIP RECORDER
(MANUAL TITLE)
MANUAL SE RI A LS PRE F I XED
_----"1"-"1'-'4""'5~A~
_
MANUAL PRINTED
MARCH, 1972
MAKE ALL CHANGES IN THIS MANUAL ACCORDING TO THE ERRATA BELOW. ALSO CHECK THE FOLLOWING TABLE FOR
YOUR INSTRUMENT SERIAL PREFIX (FIRST THREE DIGITS OF AN EIGHT DIGIT SERIAL NUMBER) AND MAKE ANY LISTED
CHANGE(S) IN THE MANUAL.
SERIAL PREFIX MAKE MANUAL CHANGES SERIAL PREFIX MAKE MANUAL CHANGES
ALL INSTRUMENTS
ERRATA
1 ?O?A
f"'l-lANr.E
1
1207A
CHANGE 2
ERRATA
Page 5-4, Paragraph 5-15,
Step g:
Page 5-5, D, 3, Step c:
Page 5-10, Step a (4):
Page 5-23, Paragraph 5-47,
Step g:
Page 5-25, Figure 5-14:
Page 6-6, Table 6-1:
Page 6-12, Table 6-1:
Page 6-14, Table 6-1:
Page 6-16, Table 6-1:
Change reference to Paragraph 5-57 to Paragraph 5-59.
Change Figure 6-15 reference to Figure 5-4.
Should read " ... by levering from front of top bar ... "
Change step to read "Remove snap ring holding sprocket
to drive roller shaft using snap ring pliers. "
C-ring 0510-1017 shown has been changed to snap-ring
0510-1012, which must be removed with snap-ring pliers.
Add on A3MP1, 7124-1605, Label 59-61 (Hz).
Change A3J6, receptacle to 1251-2995, and A3J5 to 9100-3198.
Change A9T1 to 07754-60470.
After A10MP5, add attaching part 0510-1012; Ring, retaining.
A10A1MP26 was changed in error; see Change 1.
Add to Option 008, 7124-1604, Label 49-51 (Hz).
March, 1972
DATE
PUB. 100-1
07414-91999
MANUAL PART NUMBER
A
SUPPLEMENT