Synergy SQ Instruction Manual

SYNERGY QUAD PANEL MOUNT
SQ/PM2

BEFORE YOU BEGIN

• This TV mount is intended for use with Flat-Panel TV 65" or smaller and a maximum weight capacity of 175lbs.
• Use with products heavier than the maximum weight or larger than the size indicated may result
in instability causing possible injury.
• Carefully inspect the mount for shipping damage or missing parts. If any damage is apparent or you are missing parts
contact Salamander Designs at 800-535-5659.
• Read ALL instructions before assembly. If you have any questions, please contact your installation contractor
or Salamander Designs.
• Mounts must be attached as specified in assembly instructions. Improper installation can result in serious personal injury.
PARTS
• 2 Extruded Posts
• Drill Bit
• FX200 Mount Kit
R
(2x)
301-422 Base Plate
Synergy Quad Mount Hardware Bag - PHK-523
K
(2x) 300-555
2" Button Head
L
(4x) 300-470
Metal Washer
Q
P (8x) 301-575
(2x) 301-425
V
(4x) 300-460
Plastic Fasteners
Post Cover
POKE THROUGH
USING A PENCIL
S (5x) 301-600
Wire Manager
M G F
(8x) 300-505 (12x) 300-560
(4x) 300-485
Cup Point Set Screw Flat Nut Button Head Screw
N (1x) 400-060
3/16" Hex Key
(1x) 400-070
O
1/8" Hex Key
FOLD AND ALIGN THIS BEND WITH THE REAR OF THE CABINET.
TEMPLATE

1. DRILLING HOLES

Use the center rear bolt as your template guide.

2. INSTALL BASE PLATES

A. Loosely assemble 2 at nuts (G) with 2 button
head screws (F) through each base plate (R).
G
F
R
B . Attach Both Base Plates as Shown
TIGHTEN FIRMLY WITH HEX KEY AND WRENCH.
R
2X - Along the rear edge of the cabinet, use template on the
edge of this page as a guide to drilling the hole. Line up one
hole on template with the center bolt and use the other as a
guide to mark where to drill your hole.
MARK
& DRILL & DRILL
GUIDE
TEMPLATE
REQUIRED HOLE LOCATIONS

3. INSTALL POSTS

A. Align thru holes in posts over the pins in the base plates.
Guide the at nuts (G) through the front of the posts.
If necessary, use rubber mallet or other device to ensure the
posts ts snugly agains t the top surface.
Tighten the screws (F) with hex key (H).
N
Thru Holes
K
L
L
V
POKE THROUGH
USING A PENCIL
MARK