Synergy SL Manual

SYNERGY TRIPLE PANEL MOUNT
SL/PM2

BEFORE YOU BEGIN

• This TV mount is intended for use with Flat-Panel TV 60" or smaller and a maximum weight of 175lbs.
• Use with products heavier than the maximum weight or larger than the size indicated may result in instability causing possible injury.
• Carefully inspect the mount for shipping damage or missing parts. If any damage is apparent or you are missing parts contact
Salamander Designs at 800-535-5659.
• Read ALL instructions before assembly. If you have any questions, please contact your installation contrator or Salamander Designs.
• Mounts must be attached as specified in assembly instructions. Improper installation can result in serious personal injury.
PARTS
FX 100/L
2 Extruded Posts
Fx 100/L Mount Kit
SYNERGY TRIPLE MOUNT HARDWARE BAG -PHK-516
G
F
(8x) 300-485 (16x) 300-560
Button Head Screw Flat Nut
Q
P (8x) 301-575
(2x) 301-425
Plastic Fasteners
Post Cover
R
S
(2x) (5x) 301-600
301-422 Base Plate
K L
(2x) 300-555
(2x) 300-470
2" Button Head
Metal Washer
N
(1x) 400-060
3/16" Hex Key
O
(1x) 400-070
1/8" Hex Key
S
(1x) 400-080
5/32" Hex Key
1. INSTALL BASE PLATES
A . Loosely assemble 2 flat nuts (G) with 2 button
head screws (F) through each base plate (R).
F
NOTE:
If installing mount to an assembled triple unit, remove
the two rear center connector bolts. Replace with base plates (R).
Wire Manager
M
(8x) 300-505
Cup Point Set Screw
2. INSTALL POSTS
A . Align thru holes in posts over the pins in the base plates.
Guide the flat nuts (G) through the front of the posts.
If necessary, use rubber mallet or other device to ensure the
R
(4x) 300-468
posts fits snugly against the top surface.
Black
Washer
Tighten the screws (F) w ith hex key (H).
B . Secure the base plates (R) to the two rear center posts with
the 2" button head screws (K) and washers (L)
Tig h t en fir m ly w it h h ex k ey (J ).
G
R
N
K
L
R
Thru Holes