Rack Mounting - Prism Sound Atlas Operation Manual

Prism Sound Atlas Operation Manual Revision 1.00
designated synchronization source is not connected, the sample rate reverts to local sync at
the selected sample rate.
5.6

Rack mounting

Atlas is supplied configured for table-top operation, with rubber feet attached and no rack-mount ears
fitted.
To convert for rack-mounting: First fit the rack-mount ears by removing the front three screws from
each side of the unit, using the hex key provided; then replace the same screws to retain the rack
ears. If necessary, the rubber feet can be removed by withdrawing the plastic centre-hub of each foot
a little way prior to pulling the whole foot out. The hub can be initially raised with a small flat-bladed
screwdriver. Retain the feet for later use.
If Atlas units are rack mounted, an empty 1U gap should be left above each Atlas to ensure effective
cooling.
© 2014 Prism Media Products Ltd 1.33