Cleaning And Maintenance; Electrical Shock Hazard - Dynamic 53DS---900--- --- ---117 Installation Instructions Manual

CLEANING AND MAINTENANCE

WARNING
!

ELECTRICAL SHOCK HAZARD

Failure to follow this warning could result in personal injury
or death.
Disconnect all power to unit to avoid possible electrical
shock during cleaning or maintenance. Set unit power
switch to OFF position.
N730- -03- -Edition 13/11
Copyright 2014 CAC / BDP S 7310 W. Morris St. S Indianapolis, IN 46231
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
At the beginning of each season clean the detection unit.
1. Disconnect tubing and low voltage power cord from the
detection unit and slide unit out of mounting bracket
2. Remove the top of the detection unit and take out the float.
3. Clean the detection unit and the float using a solution of
water containing 5% bleach.
4. Replace the float in its original position with the magnet
side facing up.
5. Snap cover back into place.
6. Perform an operational test (see item 13 under installation
section).
Edition Date: 04/14
12
Catalog No: IIK---53DS900---CP---07
Replaces: IIK--- 53DS900--- CP--- 06