Operation - DAPC Operator's Manual

This spray gun has a siphon and pressure feed setting. It is set at the factory for
pressure feed application.
Pressure feed mode is used for fast application of heavy material.
Siphon feed mode is used for applying light and medium bodied paints (stain,
lacquer) to large size jobs such as auto refinishing. Only external mix cap can be
used when in the siphon feed mode.
External mix cap (assembled at factory on spray
gun): The air and material are mixed after leaving
the nozzle. This method is used for fast drying
materials and when a high quality finish is desired.
Internal mix cap (supplied): The air and material
are mixed inside the air cap before being sprayed. This method is used with the
spray gun in the pressure feed mode to spray heavy duty, slow drying material.
Hex Wrench (supplied): used to remove hex screw to convert from pressure feed to
siphon feed mode.
FRONT OF FLUID NOZZLE.
CEED PRESSURE LIMIT OF GUN OR ANY OTHER COMPONENT IN
SYSTEM!
a weak or worn condition that could render system unsafe. All replacement
components such as hose or fittings must have a working pressure equal
to or greater than system pressure.
Before use
G
Install a moisture separator/regulator when there is a possibility moisture will
damage the surface to be painted. Install the moisture separator/regulator as
close to the tool as possible.
NOTE: Liquid water occurs naturally
in air lines as a result of
compression. The moisture exiting
near the compressor is warm and
still in a vapor state which allows it
to pass through the moisture
separator. The vapor must travel a
minimum of 5 to 10 feet to cool
down to a liquid to be removed by
the moisture separator. See
Illustration.
G
Prior to shipment, this gun was
treated with an anticorrosive agent. Before using this gun make sure that it is
carefully flushed with thinner.
D27122

OPERATION

DO NOT ATTEMPT TO UNCLOG (BACK FLUSH) SPRAY GUN
BY SQUEEZING TRIGGER WHILE HOLDING FINGER IN
Pressure may vary according to viscosity of material used.
Maximum working pressure of gun is 50 psi. DO NOT EX-
Prior to daily operation, make certain that all connections
and fittings are secure. Check hose and all connections for
Internal Mix Cap
4- ENG
Hex Wrench