Table of Contents
Advertisement
4. CONNECTIONS
4.4 DRIVELINE INSTALLATION:
Before using the PTO shaft, please consult the use and maintenance manual attached to the PTO shaft.
For a correct and safe operation of the machine, please use exclusively PTO shafts with CE mark.
Please use PTO shafts with integral shields.
● Grease periodically the PTO shaft following the instruction supplied by the PTO shaft
manufacturer (see the use and maintenance manual of the PTO shaft).
● Observe the sense of assembly of the PTO shaft, as indicated by the manufacturer and shown
on the outer cover of the shield (tractor drawing on the external tube of the PTO shaft towards
the power take-off of the same tractor).
● Fasten the safety anti-rotation chains after making sure that the connection between the PTO
shaft and the gearbox is well locked. Use for this connection a hexagonal head screw 8.8
10 x 70 UNI 5737 with the relative nut.
The length of the PTO shaft must be adapted to the type of tractor used.
When the PTO shaft is released from the power take-off of the tractor, it must ALWAYS be laid on the
appropriate support.
We are not responsible for damages caused by an incorrect assembly and use of the PTO shaft.
4.5 HYDRAULIC SYSTEM INSTALLATION (OPTIONAL):
In order to recognize the element used, please refer to the tables 08 and 09 of the parts breakdown sections.
1. Assemble the connection plate for hydraulic opening system (ref. 8) on the gearbox by using the
screw and the nut (C) already on the gearbox.
2. Fixing the hydraulic cylinder (ref. 1) to the connection plate (ref. 8) by using the screw (ref. 4)
hexagonal head 8 x 30 (mod. PDV500/600) or hexagonal head 8 x 25 (mod. PDV800), the self-
locking nut M8 (ref. 6), the two washers 8 x 17 (ref. 7) and the bushing 13 x 8 x 7 (ref. 9).
3. The hydraulic cylinder stem must be connected to the lever plate in the hole B. Insert the screw
hexagonal head 12 x 60 (ref. 3) in the hole B, screw up the nut M12 (ref. 10) insert the screw in
one of the two cylinder holes and fi x it by the self-locking nut M12 (ref. 5).
ATTENTION!
Check the rotation sense and the speed regulation of the power
take-off of the tractor to be at 540 r.p.m., as the machine is projected
for this kind of speed.
12
Advertisement
Table of Contents
