Table of Contents
Advertisement
VBOX HD MANUAL
Lap timing
Using the OLED display
When setting up the
DSP04
OLED display with a VBOX HD, it is important to
connect to the correct port of the OLED display. The OLED display only has
a serial connection on the lower connector, with the buttons on the right
hand side - as shown in this picture.
The configuration is indicated on a label on the rear of the OLED display.
To connect either a DSP04 or DSP05 OLED to VBOX HD, connect the OLED cable
into the 'AUX' port.
Auto track map
– Once a GPS location is detected, the VBOX HD will load a start/ finish line for that location in
order to allow a connected OLED to detect it without any other setup. The desired layout being used can then be
defined through the OLED main menu.
e.g. If Silverstone location is detected, Combo, GP, GP Classic SF, National, International and Stowe SF lines will be
available to select.
Upgrading firmware
Occasionally Racelogic will release new versions of firmware (internal code) for the VBOX HD, often to introduce or
support new features. New firmware is loaded into the VBOX using an SD card.
The latest file is always on our website:
www.vboxmotorsport.co.uk
(firmware can be found under 'customer area').
Copy this file onto an SD card (not into the 'media' folder), and insert into a powered unit. As the update progresses,
the Status LED will flash. After a period of up to two minutes, the unit will beep twice and resume operation. The unit
should then be power cycled, note that the upgrade file will have been deleted from the SD card.
Page | 7
30 July 2014
Advertisement
Table of Contents
