Table of Contents
Advertisement
Light Diagnostics Table D10-8 & C10-8
Light
Led 1
Led 2
System
Illuminated
Operation
FULLY
Illuminated
FULLY
Illuminated
FULLY
Low System
Flashing
Fading
Pressure
Quickly
IN-OUT
Service
Flashing
Motors
Slowly
Flashing
Quickly
Flashing
Quickly
Flashing
Illuminated
Quickly
FULLY
Service
Filters
Flashing
Quickly
Filter Auto
Illuminated
Clean
FULLY
(iVac Only)
Illuminated
FULLY
Fading
IN-OUT
Fading
Led 3
Led 4
Led 5
Illuminated
FULLY
Fading
IN-OUT
Flashing
Slowly
Fading
IN-OUT
Flashing
Slowly
Flashing
Quickly
Fading
IN-OUT
Illuminated
FULLY
Flashing
Slowly
Flashing
Quickly
Illuminated
FULLY
OFF
Illuminated
Audible
Condition
Alert
None
Unit is operating using POWER button
on panel, no remote signal
None
Unit is operating using remote signal
(or mc2 signal if provided)
None
Shutdown delay
(Remote /mc2 signal has been removed)
None
Unit is in Standby mode, waiting for
remote signal (or mc2 signal if
provided) to start unit
Beep
Abnormally Low
Pressure, Unit has or
Every
Will Shut Down If Not Corrected
Second
Beep
50 hrs of life left in brushes
Every 4
Hours
Beep
30 hrs of life left in brushes
Every
15 Mins
Beep
10 hrs of life left in brushes
Every 5
Mins
Beep
Motor Brush Life Expired Unit Shut
Every
Down
Second
None
Filter Pressure High
Beep
Filter Pressure Close To Critical
Every
Hour
Beep
Critical Pressure, Unit Shut Down
Every
Second
Beep
Replace Filter (s) ASAP
Every
Hour
None
Unit in operation & filters are
scheduled to be cleaned the next time
unit is shut off for more than 5
seconds
None
Unit is OFF, filter being cleaned
None
Unit in operation.
ALERT, filter cleaning motor not
operating at optimum
None
Unit is in Constant AUTO Cleaning Mode
Vacuum Controlled By POWER Button On
Control Panel
None
Unit is in Constant AUTO Cleaning Mode
Action
Using The POWER button while L5 is
Flashing SLOWLY will temporarily
disable any active remote standby.
To Re-Establish STANDBY turn the
unit off using the POWER button.
Check Motor(s), Check Motor Brushes,
Verify If Filters Are Installed,
Close All Filter Access Points
Order brushes if not already on
hand.
If brushes on hand change now and
reset alert.
Unit Will SHUT DOWN In 30 Hours to
prevent motor damage
Unit Will SHUT DOWN In 10 Hours to
prevent motor damage
Replace ALL motor brushes.
Reset Brush Life Alert
See Video Link:
www.youtube.com/watch?v=LOm81obvaDE
Prepare To Replace/Service Filters
Replace/Service Filters Now.
Continued Operation Will Result In
Unit Shutdown
Verify Blockage, Verify All Filters
Replace Filter (s) ASAP
Reset Filter Life Alert
See Video Link:
www.youtube.com/watch?v=LOm81obvaDE
Replace Filter Cleaning motor
Unit Automatically
Shuts OFF
Vaccum , Cleans & The ReStarts
Vaccum
Unit Automatically
Shuts OFF
Advertisement
Table of Contents
