Page 1
Antiference HDMI Matrix instruction Manual 2 x 4 Matrix Switch HDMI0204M 4 x 4 Matrix Switch HDMI0404M (the above doesn’t include IR Kit) & 4 x 4 Matrix switch over Cat5e/6 cable HDMI0404MUTP (HDMI0404MUTP includes receivers and IR kit) WARNING! DO NOT HOT-PLUG HDMI CABLES.
Page 2
The use of wallplates and patch panels always has the potential to cause increased resistance on the cable, introducing ‘pinch points’ for signal transmission and could reduce advertised transmission lengths. TIP – instead of using RJ45 wallplates, use the Antiference brush plates instead to maintain the neat finish. Connection termination Terminate the cabling using RJ45 connectors to the 568B wiring standard (shown below) www.antiference.co.uk...
Page 3
Staggering the IRTX has been found to help the IR signals not get disrupted by other source IR commands . When using the HDMI adaptor with the HDMI0204M & HDMI0404M make sure its always switched to IR. IR Ext Port You can connect an IR RX cable to the 3.5mm jack port labeled IR ext if you wish to retain IR...
Page 4
IR EXT cable and also via the IR RX cables connected to the TV receivers. (sometimes referred to as a ‘magic eye’) Additional remotes are available to purchase. Troubleshooting Troubleshooting and Specifications are available on our website. www.antiference.co.uk...
Need help?
Do you have a question about the HDMI0204M and is the answer not in the manual?
Questions and answers