Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Kärcher G 2600 FCE
Summary of Contents for Kärcher G 2600 FCE
- Page 1 ® G 2600 FCE G 2800 FCE English Español Français 8.752-007.0 04/12...
-
Page 2: Table Of Contents
Troubleshooting Specifi cations Owner/User Responsibility The owner and/or user must have an understand- G 2600 FCE ing of the manufacturer’s operating instructions Operating Pressure 2600 PSI and warnings before using this pressure washer. Warning information should be emphasized and Water Volume 2.5 GPM... -
Page 3: Model Overview
MODEL OVERVIEW Handle Water Inlet With Garden Hose Connector Trigger Gun Quick Connect High Pressure Outlet Trigger Gun Safety Lock 10. Detergent suction tube with fi lter High Pressure Hose 11. Dipstick Gas Tank 12. Quick Connect Nozzles Spray Wand For Engine Details See Engine Manual Nozzle Holder English 3... -
Page 4: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS ■ ■ Read the operating instructions of the engine Do not use acids, solvents, or any fl ammable manufacturer before start-up and follow the or alkaline material in this product. These safety instructions carefully. products can cause physical injuries to the operator and irreversible damage to the ma- WARNING chine. -
Page 5: Assembly Instructions
WATER SUPPLY (Cold Water Only) ■ CAUTION Flow rate can be determined by running the water for one minute into an empty 5-gallon When connecting to water supply mains, local container. regulations of your municipal water company ■ must be observed. In some areas connecting The water supply temperature must not ex- directly to public drinking water supply may ceed 104°F/40°C. - Page 6 Hardware (included) Description Purpose Illustration Spray Gun Spray Gun Assembly Quick Nozzles Kit Assembly Connect Nozzle Kit (5 pc.) Wand Wand Assembly Nylon Rivet Gun Holder Assembly Assembling Scan QR Code with smartphone for detailed instructions STEP 1: STEP 3: Attach the handle to the frame of the pressure Place the quick connect nozzles (H) in the washer.
-
Page 7: Operating Instructions
Assembling STEP 5: Place the Spray Gun (G) into the Gun Holder (E) and the Wand (I) into the Wand Holder (D). OPERATING INSTRUCTIONS STEP 1: STEP 2: Pull the spring-loaded collar of the wand Pull back the spring loaded collar at the spray back to insert your choice of quick connect gun and insert the high pressure hose. - Page 8 OPERATING INSTRUCTIONS CAUTION CAUTION Engine Shipped without oil. Before starting High pressure in quick connect area. engine, fi ll with oil. Do not over-fi ll. Do not run Risk of injury caused by improperly locked the engine with a high or low oil level as this high pressure hose.
-
Page 9: Using The Accessories
OPERATING INSTRUCTIONS STEP 11: After the engine warms up enough to run smoothly, move choke rod to OFF position. Pull the starter handle. If the engine fails to start after 3 pulls, squeeze the trigger gun to release pressure, and repeat step. For engine details see engine manual. -
Page 10: Taking A Break
WORKING WITH DETERGENTS STEP 3: STEP 4: With the engine running, pull trigger to operate Always draw fresh water through the deter- unit. gent suction tube when the cleaning job is done, to rinse/fl ush any remaining detergents Liquid detergent is drawn into the unit and from the injection system. -
Page 11: Winterizing And Long-Term Storage
Kärcher-Authorized Service Center for repair. (You can locate a service center in your area online at: www.karcher-service.com). CLEANING TIPS Deck Cleaning House Siding (with or without detergent). -
Page 12: Optional Accessories
Cement Patios, Brick and Stone Patio & Lawn Furniture (with or without detergent). Pre-rinse furniture (with or without detergent). Pre-rinse cleaning and surrounding area with fresh water. If using surface with fresh water. If using Kärcher Pres- Pressure Wash, apply to surface at low pressure. sure Wash or Degreaser, apply to surface at low Allow Pressure Wash to remain on surface 1-3 pressure. -
Page 13: Troubleshooting
TROUBLESHOOTING CAUTION Remove the spark plug cable to prevent accidental ignition of the engine before making any repair Symptom Cause Solution ENGINE WILL NOT No gasoline Fill gas tank START Choke is not in the correct Slide choke lever out to closed position position Water pressure built up in Squeeze the trigger to release the pressure... - Page 14 Turn the swivel nut of the gun clockwise until connection is tight LEAKS attached Broken o-ring or plastic Visit www.karcher-help.com or locate a ser- vice center at www.karcher-service.com insert PUMP IS NOISY Not enough gas or engine Check that hoses and fi ttings are air tight.