Batteries Replacement; Arming The System; Arming The System With Sensors Deactivation; Arming The System With A Running Engine - Gorgon G303 Operation Manual

REMOTE'S BATTERIES REPLACEMENT
Low battery symptoms are as follow: dimming of the remote's indicator or decreasing of its operative range.
In this case you should replace the battery in the remote control unit.
• unscrew the fastening and remove the upper part of the remote's case;
• keeping the PCB on its place, change the battery for a new one (A27 +12V type) observing polarity;
• put the upper part of the case back on its place, check the buttons pressing and screw the fastening.

ARMING THE SYSTEM

The system can be armed either with the ignition turned on or off. With ignition turned off the system
can be transferred either to the complete security mode with a control over all available sensors, or to the
security mode with one or several sensors deactivation. In both of these modes the system LED signals
with a short red flashes.
To turn the system to the complete security mode - just press button "1" of the remote control. The
system will confirm the performance of command by a single flash of parking lights. To get a sonic confir-
mation of the command performance – press button "1" again within a 1,5 seconds period.
ARMING THE SYSTEM WITH THE SENSORS DEACTIVATION
To arm the system with a built-in shock sensor deactivation: press button "1" of the remote unit,
release it within a 1,5 seconds period and then press button "2". The system will produce two signals of
the parking lights.
To arm the system with an external double-area sensor deactivation: press button "1" of the remote
unit, release it within a 1,5 seconds period and then press button "3". The system will produce three sig-
nals of the parking lights.
To arm the system with both built-in and external double-area sensors deactivation (perimeter se-
curity): press button "1" of the remote unit, release it within a 1,5 seconds period and then press buttons
"1"& "3" simultaneously. The system will produce four signals of the parking lights.

ARMING THE SYSTEM WITH A RUNNING ENGINE

With ignition turned on the system can be transferred to the perimeter protection mode with a running
engine. For this purpose press and release remote's button "1" and then, within a 1,5 seconds period,
press and release button "1". The system will produce one signal of the parking lights.
In this case the engine interlock circuit will be DISABLED and the system will automatically deactivate
external built-in shock sensor to avoid system response from the engine's vibration.

REARMING THE SYSTEM

If within 30 seconds upon the system disarming neither doors nor hood and trunk have been opened,
then the system automatically turns to the mode of complete security (if such option was set during pro-
gramming-sublevel 4.2). During the countdown of this period the LED shines with red light.
Each pressing of the button "2" extends for 30 seconds the time left to rearming activation. The sys-
tem produces two signals of the parking lights, sends command to open the locks and, if it's allowed by a
pre-programmed feature (sublevels 6.1, 6.4), gives command to turn on the pager or timer channel #3.
If within a 1,5 seconds period the button "2" is pressed twice the system additionally activates a double
signal of siren.

IMMOBILIZER

If within a 25 seconds period upon opening of a door, hood or trunk the ignition has not been activated,
then the system interlocks the engine start-up and turns to the immobilizer mode (if this feature has been
assigned during programming – sublevel 4.1). In this mode the LED flashes with red and green lights alter-
nately. Press any button of the remote unit to exit this mode. System's LED will go down.

Gorgon G3O3