JVC LYT1729-001B Instructions Manual page 48

Changing the Menu Settings (Continued)
{
CONTINUOUS SHOOTING
Records still images continuously
while the SNAPSHOT button is
pressed.
z
SELF-TIMER
Starts recording when the
set time elapses after the
SNAPSHOT button is pressed.
3 REC MEDIA FOR IMAGE
Enables you to set the recording
medium for still images.
g
BRIGHT
Enables you to set the brightness
of the LCD monitor.
^
DROP DETECTION
Prevents damage to the
HDD by turning off the power
automatically when the camera
detects that it has been dropped.
]
REMOTE
Turns reception of the operation
signal from the remote control
on/off.
[
DEMO MODE
Introduces special features of the
camera at the following cases.
•
When the menu screen is
closed.
•
When there is no operation
for about 3 minutes during
recording mode.
\
OPERATION SOUND
Enables you to set the operation
sound or turn the operation
sound on/off.
48
Menus Settings: [ ] = Factory-preset
[OFF] : Disables the function.
ON : Activates the function.
NOTES
•
The interval between recording still images is approx. 0.3
seconds.
•
Continuous shooting may not work well depending on the
recording medium.
•
The continuous shooting speed will drop if this function is
used repeatedly.
[OFF] / 2SEC / 10SEC
[HDD] / SD
Adjust the brightness of the display moving the set lever
to £ / ¤, then press down.
OFF : Disables the function.
[ON] : Activates the function.
To turn the unit on when the drop detection worked, set
the power/mode switch to OFF, and to ON again.
CAUTION
Setting this function to off increases the chances of
damaging the built-in hard disk if the camera is accidentally
dropped.
OFF : The camera does not receive the signal from the
remote control.
[ON] : Enables operation with the remote control.
OFF : Disables the function.
[ON] : Activates the function.
NOTES
•
The demonstration only works when the DC cord is
connected, not with the battery.
•
If an SD card is in the camera, demonstration will not take
place even if this mode is set to [ON].
OFF : Turns off the operation sound.
[MELODY] : The melody sounds when any operation is
performed.