ASROCK M810LMR User Manual page 14

Mainboard User's Manual
Installing a Socket-462 Processor
A processor installs into the ZIF (Zero Insertion Force) Socket-462
on the mainboard.
1. Locate the Socket-462 and CPU/PWRFAN. Pull the locking
lever out slightly from the socket and raise it to the upright
position.
2. On the processor, identify the Pin-1 corner by its beveled edge.
3. On the Socket-462, identify the Pin-1 corner. The Pin-1 corner
is at the top of the locking lever when it locked.
4. Match the Pin-1 corners and insert the processor into the
socket. No force is required and the processor should drop into
place freely.
5. Swing the locking lever down and hook it under the catch on
the side of the socket. This secures the CPU in the socket.
6. All processors should be installed with a combination
heatsink/cooling fan (the original fan is recommended, the
others' fan is not), connect the cable from the fan to the CPU
fan power connector CPU/PWRFAN.
10
Socket-462
Pin-1 Corner
CPU/PWRFAN