Table of Contents
Advertisement
Backlight Compensation
Backlight compensation brightens the subject
quickly. With simple operation, dark portions of
the subject are brightened by increasing the
exposure.
1
Set the power switch to
2
Press and hold
displayed.
3
Press
(
) once so that the
appears.
To cancel backlight compensation
Press
(
) twice so that the
disappears.
Spot Exposure Control
Selection of a spot metering area enables more
precise exposure compensation. You can select
one of the three metering areas.
1
Set the power switch to
2
Press and hold
displayed.
3
Press
(
) twice so that the
appears.
The spot metering area frame
centre.
4
Press
/
to select the desired spot
metering area frame.
5
Press 49. The setting is completed.
To lock the exposure
After step 4, press and hold 49 for over 2
seconds. The
indicator appears.
To cancel spot exposure control
Press
(
) once so that the
disappears.
NOTES:
Spot exposure control may not be possible when
some other functions are activated.
Depending on the shooting location and condition,
optimum result may not be attained.
.
(
/ ) so that
is
indicator
indicator
.
(
/ ) so that
is
indicator
appears at the
indicator
RECORDING FEATURES
Flash
/
You can use the flash for still image recording.
The flash mode can be changed as required.
FLASH
1
Set the power switch to
2
Set the MODE switch to
/
3
Press FLASH repeatedly to select the
desired flash mode.
The selected mode indicator will be displayed on
the screen.
[AUTO]: The flash fires automatically when
the surroundings are dark.
AUTO RED-EYE: The flash fires
automatically but reduces the red-eye
phenomenon of the subject's eyes.
ON: The flash fires regardless of the shooting
condition.
SLOW SYNCHRO: The flash fires
regardless of the shooting condition. The shutter
speed becomes slower in this mode, so the
background can also be brightened.
[ ] = Factory-preset
When not using the flash
Press FLASH repeatedly until no flash mode
indicator is displayed on the screen.
NOTES:
The flash and the continuous shooting cannot be
used at the same time. The unusable mode
indicator blinks or goes out.
The flash mode indicator also blinks while
charging the flash.
If the flash mode is selected before turning the
LCD monitor, you can continue to use the flash
after the LCD monitor is turned 180°, even though
the flash mode indicator will disappear. The flash
mode cannot be selected after the LCD monitor is
turned 180°. (
If the flash is not bright enough, set [GAIN] to
[AUTO] or [160]. (
[S.SP] to [NIGHTSCOPE] in the MSET menu.
(
pg. 35)
.
.
pg. 9)
pg. 51) Alternatively, set
31
EN
Advertisement
Chapters
Table of Contents
