Cautions - JVC LYT0201-001A Instructions Manual

82
EN
Battery Packs
The supplied battery pack is a
lithium-ion battery. Before using
the supplied battery pack or an
optional battery pack, be sure to
read the following cautions:
1. To avoid hazard . . .
.... do not burn.
.... do not short-circuit the terminals.
.... do not modify or disassemble.
.... do not expose the battery to temperatures
exceeding 60°C, as this may cause the battery
to overheat, explode or catch fire.
.... use only specified chargers.
2. To prevent damage and prolong service life . . .
.... do not subject to unnecessary shock.
.... charge in an environment where temperatures
are within the tolerances shown in the chart
below. This is a chemical reaction type
battery—cooler temperatures impede chemical
reaction, while warmer temperatures can
prevent complete charging.
.... store in a cool, dry place. Extended exposure
to high temperatures will increase natural
discharge and shorten service life.
.... fully charge and then fully discharge the
battery every 6 months when storing the
battery pack over a long period time.
.... remove from charger or powered unit when
not in use, as some machines use current even
when switched off.
NOTES:
It is normal for the battery pack to be warm after
charging, or after use.
Temperature Range Specifications
Charging ............... 10°C to 35°C
Operation ............. 0°C to 40°C
Storage ................. –10°C to 30°C
Recharging time is based on room temperature of
20°C.
The lower the temperature, the longer recharging
takes.
Cassettes
To properly use and store your cassettes, be sure to
read the following cautions:
1. During use . . .
Terminals
2. Store cassettes . . .
LCD monitor
1. To prevent damage to the LCD monitor,
2. To prolong service life . . .
3. Be aware of the following phenomena for LCD
•While using the camcorder, the surface around the
•If you leave power on for a long time, the surface
.... make sure the cassette bears the Mini DV
mark.
.... be aware that recording onto prerecorded
tapes automatically erases the previously
recorded video and audio signals.
.... make sure the cassette is positioned properly
when inserting.
.... do not load and unload the cassette
repeatedly without allowing the tape to run at
all. This slackens the tape and can result in
damage.
.... do not open the front tape cover. This exposes
the tape to fingerprints and dust.
.... away from heaters or other heat sources.
.... out of direct sunlight.
.... where they won't be subject to unnecessary
shock or vibration.
.... where they won't be exposed to strong
magnetic fields (such as those generated by
motors, transformers or magnets).
.... vertically, in their original cases.
DO NOT . . .
.... push it strongly or apply any shocks.
.... place the camcorder with the LCD monitor on
the bottom.
.... avoid rubbing it with coarse cloth.
monitor use.
These are not malfunctions. . . .
LCD monitor and/or the back of the LCD monitor
may heat up.
around the LCD monitor becomes hot.

CAUTIONS