Before Using For The First Time - Capresso 275 Operating Instructions Manual

H2o pro programmable cordless water kettle with variable temperature control
Table of Contents

Advertisement

B EFORE USING FOR THE FIRST TIME
R ead all Important S afeguards and Operating Instructions before using
this k ettle. Discard the first filling of boiling water to remov e any dust
and residues from the manufacturing process.
1 . TO B OIL W ATER (d e fa u lt s e ttin g )
1 . R emov e k ettle from base.
2. Push the button on the lid (Fig. 1 A). The lid opens itself.
3 . Fill with the desired amount of fresh cold water. The k ettle has
minimum and max imum mark ings. N ev er underfill or ov erfill the k ettle.
CAUTION / DANGEROUS: N ev er fill abov e the MAX line. If you fill
abov e the max line, boiling water will push out of the pouring spout.
This can cause sev ere injuries and burns.
4 . Close lid.
5. Place k ettle on Power Base (Fig. 1 G).
6. Plug cord into outlet. The display illuminates and shows the k ettle
symbol and 21 2º F (Fig. 3 a).
7. Push the On/Off button (Fig. 2d). The k ettle symbol will blink , indicating
that the k ettle is heating the water. The warmer the water becomes
the more you will hear the noise of the water heating up.
8 . When the water comes to a boil the display will switch from the k ettle
symbol to the timer symbol (Fig. 3 d). The timer symbol will blink for
three seconds (default). Then the display changes back to the k ettle
symbol (not blink ing) and the heater shuts off.
9 . L ift k ettle from base and pour water out slowly. For different settings
see chapters 4 , 5 and 6.
2 . DRY B OIL SHUT- OFF PROTECTION
If you turn the k ettle on without water in the k ettle, the heater will shut
off after a few seconds. The display will go blank . Once the k ettle has
cooled down, the display will come back on again. This can tak e sev eral
minutes. To speed up this process you can fill some cold water into the
k ettle. Y ou will hear a click ing noise. This indicates that the thermostat
has reset itself. If you place the k ettle back on the power base, the
display will show the default setting again (Fig. 3 a).
Please note: AU TO-OFF. The k ettle will always shut-off after the selected
temperature has been reached.
7.

Advertisement

Table of Contents
loading

This manual is also suitable for:

276H2o pro 275H2o pro 276

Table of Contents