Connection - JVC LYT0089-001A Instructions Manual

D.S.C. PLAYBACK
Set to "D.S.C."
For Macintosh ® :
To Modem Port
or Printer Port
Viewfinder
PC MODE
NOTES:
Before transferring still images from your personal computer to the camcorder's built-in memory, perform
the camcorder's Picture Mode Setting (
computer in the selected Picture Mode.
When transferring still images from your personal computer to the camcorder, make sure the number of
images to be transferred is smaller than the camcorder's remaining number of shots available.
Use the AC Power Adapter/Charger as the power supply instead of the battery pack.
The still images stored in the camcorder's memory are not automatically removed after being transferred to
the PC. If you wish to remove those still images from the camcorder's memory, delete them (
Windows are trademarks of Microsoft Corporation, registered in the U.S.A. and other countries.
®
Macintosh ® are trademarks of Apple Computer Inc., registered in the U.S.A. and other countries.

Connection

To DIGITAL jack
(8-pin)
PC connection
cables (provided)
®
For Windows :
To COM Port
(RS-232C)
pg. 47). The still images will be transferred from the personal
Connection to a Windows
Image data stored in the camcorder's built-in memory
can be transferred to a Windows
saved using the provided image transfer software. The
image data transferred to a personal computer can also
be further processed using Paint Software, and the still
image processed on the PC can be inserted onto a tape
( pg. 71).
CONNECT TO PERSONAL
COMPUTER
1
Connect the camcorder's DIGITAL jack to the COM
Port (RS-232C) on a Windows PC or to the Modem
Port/Printer Port (8-pin) on a Macintosh, using the
provided PC connection cable.
SELECT MODE
2
Set the System Select Switch to "D.S.C.", then set
the Power Switch to "PLAY".
•A still image stored in memory appears.
•When transferring still images to a computer, be
sure that a still image is displayed on the screen.
RUN IMAGE TRANSFER SOFT-
WARE
3
Launch the provided software on your Windows
®
PC or Macintosh . Transfer the still images stored in
the camcorder's memory to the Windows
®
Macintosh . Refer to the software's instruction
manual on the provided CD-ROM for details.
•During transfer of the still image, the camcorder's
screen becomes blue and "
played. After transferring is finished, the screen
displays the same still image as in step 2.
END TRANSFERRING
4
Close the software, then switch off the camcorder.
61
EN
PC/Macintosh
® ®
® PC or Macintosh ® and
®
®
PC or
" is dis-
PC MODE
pg. 58, 59).