Do you have a question about the ULTRASlimline 10111 and is the answer not in the manual?
Questions and answers
Ali Rezamand
May 22, 2025
Hi the Manual is not helping for the explode and explain to open the fan and find out the place of making noise to fix. why it has to explain the trouble shooting too are you sure this is a Manual???
1 comments:
Mr. Anderson
May 25, 2025
The provided context does not include specific troubleshooting steps for noise issues with the Seville Classics ULTRASlimline 10111 fan. However, general troubleshooting steps may include:
1. Ensure the fan is on a flat, stable surface. 2. Check for any loose parts or screws and tighten them. 3. Make sure nothing is obstructing the fan blades or airflow. 4. Confirm the fan is assembled correctly according to instructions. 5. If the fan has been dropped or is damaged, do not operate it.
If the noise persists, contact a qualified technician or the manufacturer.
This answer is automatically generated
Violet Desjarlais
March 21, 2025
What size are the gold screws that go with the base, I can't find them & i need 4
1 comments:
Mr. Anderson
May 14, 2025
The size of the gold screws for the Seville Classics ULTRASlimline 10111 base is not provided in the context.
This answer is automatically generated
Michael Maddox
June 9, 2025
I need the fan for a Seville Classics Tower Fan Model 10111
Do you have just the fan part? It's about 23.5 inches including the metal shaft. There are seven fan sections but the blades on one of the sections just broke in to small pieces and I need to replace this fan part.
Subscribe to Our Youtube Channel
Related Manuals for Seville Classics ULTRASlimline 10111
Page 2
Parts List Fan Assembly STEP 1 Turn the base upside down. Unscrew the 2 base SCREWS and base CLIPS from posts on the BASE-back . Firmly snap the BASE-front onto the BASE-back by aligning the four holes onto the four posts. Replace the SCREWS and CLIPS that the clips wraps over the BASE-back and tighten.
Page 3
Fan Assembly Control Panel STEP 3 Pass the Power Cord through the center hole in the center of the BASE. Align the BASE front with the FAN front and insert the four posts on the FAN body into the four holes on the top of the BASE, it will only go one way. Place the 4 SCREWS into the holes through the bottom of the base and tighten securely.
Page 4
Control Panel Control Panel (2) Low Natural Wind - The wind settings will repeat the following 80 second wind cycle with Low speed being the most common. Low Speed One cycle High Selection of Wind: Allows for three different wind modes: 1.
Page 5
ULTRASlimline Remote Control for Tower Fan Note This equipment has been tested and found to comply with the limits for Clss B digital To use your remote, point the top end directly at the front of the device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason- able protection against harmful interference in a residential installation.
Page 6
If it still does not fit, contact a qualified electrician. suggestions please contact us at: Do not attempt to defeat this safety feature. Seville Classics Inc. 6. A loose plug/outlet connection may cause overheating and distortion Tel: (800)-323-5565 or (310)-533-3800 of the plug.
Need help?
Do you have a question about the ULTRASlimline 10111 and is the answer not in the manual?
Questions and answers
Hi the Manual is not helping for the explode and explain to open the fan and find out the place of making noise to fix. why it has to explain the trouble shooting too are you sure this is a Manual???
The provided context does not include specific troubleshooting steps for noise issues with the Seville Classics ULTRASlimline 10111 fan. However, general troubleshooting steps may include:
1. Ensure the fan is on a flat, stable surface.
2. Check for any loose parts or screws and tighten them.
3. Make sure nothing is obstructing the fan blades or airflow.
4. Confirm the fan is assembled correctly according to instructions.
5. If the fan has been dropped or is damaged, do not operate it.
If the noise persists, contact a qualified technician or the manufacturer.
This answer is automatically generated
What size are the gold screws that go with the base, I can't find them & i need 4
The size of the gold screws for the Seville Classics ULTRASlimline 10111 base is not provided in the context.
This answer is automatically generated
I need the fan for a Seville Classics Tower Fan Model 10111 Do you have just the fan part? It's about 23.5 inches including the metal shaft. There are seven fan sections but the blades on one of the sections just broke in to small pieces and I need to replace this fan part.