FWE R SERIES Operating Instructions Manual page 3

Q
Q
Q
UICK-
G U I D E
"COLD-TEMP" FOOD SENTRY SYSTEM
-
POWER ON / OFF Turns cabinet ON and OFF.
Also Changes Display to °Celsius or °Fahrenheit Scale:
You may change the Digital thermometer scale to either
°C or °F as follows: While unit is OFF, press and hold the
"ON/OFF" key for five (5) seconds. The display will then
switch from "dgF" to "dgC" . Repeat to change scale again.
Power Indicator Light -
Indicates that the power is on.
Temp Display - Digital temperature display shows
the temperature of the cabinet.
"dgF" = Degrees Fahrenheit
"dgC" = Degrees Celsius
You may change the Digital thermometer scale to
either °C or °F as follows: While unit is OFF, press
and hold the "ON/OFF" key for five (5) seconds.
The display will then switch from "dgF" to "dgC" .
Repeat to change scale again.
Cycling Indicator Light -
When light is "ON" , this indicates that the
cabinet is cooling down to desired temperature.
When cooling elements are activated, light will
come "ON" until cabinet has reached desired
temperature, and go "OFF" when unit has
reached desired temperature.
S
TART
TEMP SETTING - Raising the Temperature
Press to raise the temperature of the cabinet.
TEMP SETTING - Lowering the Temperature
Press to lower the temperature of the cabinet.
TEMPERATURE RECALL
Press to display either "Actual Internal Cabinet"
actual temperature, or desired "Set Point" temperature.
Actual: The factory default setting shows the actual internal cabinet temperature
and acts as a digital thermometer. A momentary touch of the "Temp Recall" key
will recall the original dial setting. The display will then automatically return to the
actual internal temperature.
Set Point: To have temperature read-out display the "Set Point" temperature,
press and hold the "Temp" key for five (5) seconds. The fourth (4th) digit on the
display will flash either "S" (Set), or "A" (Actual) to indicate which mode is active.
To switch back again, repeat this step holding the "Recall Temp Set"
key for five (5) seconds.
Activated red light indicates DEFROST is in progress.
DEFROST CYCLE - "ON DEMAND" DEFROST
Press to ACTIVATE DEFROST at any time.
Press to CANCEL DEFROST in progress (Defrost Override).