Installation; Installation Warnings And Tips - B52 marine BMP 4004 Instruction Manual

INSTALLATION

WARNING
Playing loud music in a ship can hinder your ability to hear traffic and permanently damage your
hearing. We recommend listening at low or moderate levels while driving your boat. B52 accepts
no liability for hearing loss, bodily injury or property damage resulting from the use or misuse of
this product.
IMPORTANT
To get the best performance from your B52 BMP-4004 Series amplifiers, we strongly
recommend that installation be entrusted to a qualified professional. Although these instructions
explain how to install B52 BMP-4004 Series amplifiers in a general sense, they do not show
specific /installation methods that may be required for your particular vehicle. If you do not have
the necessary tools or experience, do not attempt the installation yourself. Instead, please ask
your authorized B52 car audio dealer about professional installation.

INSTALLATION WARNINGS AND TIPS

• Always wear protective eyewear when using tools.
• Turn off all audio systems and other electrical devices before you start. Disconnect the (-)
negative lead from your vehicle's battery.
• Check clearances on both sides of a planned mounting surface before drilling any holes or
installing any screws. Remember that the screws can extend behind the surface.
• At the installation sites, locate and make a note of all fuel lines, hydraulic brake lines,
vacuum lines, and electrical wiring. Use extreme caution when cutting or drilling in
and around these areas.
• Before drilling of cutting holes, use a utility knife to remove unwanted fabric or vinyl to
keep material from snagging in a drill bit.
• When routing cables, keep input-signal cables away from power cables and speaker wires.
• When making connections, make certain they are secure and properly insulated. If the
amplifier's fuse must be replaced, use only the same type and rating as that of the original.
Do not substitute another kind.
4