RotoZip CR18L Operating/Safety Instructions Manual page 8

RZ 2610955692 11-08:RZ 2610955692 11-08 11/10/08 9:24 AM Page 8
Disconnect battery pack
!
W RNING
from tool or place the switch
in the locked or off position before making
any assembly, adjustments or changing
accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
Make certain that the collet nut is securely
tightened before turning the tool on.
REMOVING, INSTALLING, AND
ADJUSTING THE DEPTH GUIDE
In order to remove the depth guide from the
tool, turn the thumb screw counter-clockwise
until you can remove it from the tool. The
depth guide should then pull freely from the tool.
To reattach the depth guide, line up the slot in
the depth guide with the threaded hole in the
metal housing and re-install the thumb screw
by rotating it clockwise until tight. Be careful
not to cross-thread the thumb screw.
The depth guide allows you to control the
depth of cut. Loosen the thumb screw by
CHANGING THE COLLET
The bit flutes are sharp and
!
W RNING
should be handled with
caution.
The 1/8" collet is used with 1/8" diameter
bits, the 1/4" collet is used with 1/4" diameter
bits and the 5/32" collet is used with 5/32"
diameter bits.
To change collets, loosen the collet nut with
the included wrench and remove the bit.
Continue to loosen and unscrew the collet
nut until you can remove it from the tool.
Remove the collet and replace it with the
other (Fig. 3).
INSTALLING BITS
The bits are held by a collet system. Use either
the 1/8", 1/4" or 5/32" collet depending on the
size of the bit shank.
Depress and hold the shaft-lock in and rotate
the collet nut and shaft until the shaft-lock
engages and holds the shaft. Use the
included wrench to loosen the nut by rotating
it counter-clockwise (Fig 4).
Insert the bit into the collet so approximately
1/8" of the shank exposed. Re-engage the
shaft lock and tighten the nut by rotating it
Assembly
turning it counter-clockwise until the depth
guide can slide freely on the metal housing.
For bits with a guide point (Drywall XBITS™,
Guidepoint and Window & Door Zip
®
make sure that the entire guide point tip will
extend 1/8" beyond the material thickness
(Fig. 2). For standard point drywall Zip
make sure that the fluted end of the bit
extends 1/8" beyond the material thickness.
THUMB SCREW
(Each collet is double-ended, and either end
is acceptable to use.) By hand, re-tighten
the collet nut around the collet in a clockwise
direction. You are now ready to insert a new
bit as instructed in Installing Bits (Fig. 4).
SH FT
LOCK
OUTPUT SH FT
clockwise by hand, then with the wrench until
the bit is held securely.
SH FT
LOCK
COLLET NUT
-8-
bits)
®
bits,
®
1/8"
FIG. 2
FIG. 3
COLLET
COLLET
NUT
FIG. 4
1/8"