Page 1
Thank you for choosing Nawras E5 II Wi-Fi modem Nawras E5 II Wi-Fi modem is a high-speed packet access (HSPA) USB modem. You can connect E5 II with the USB interface of a computer, or via Wi-Fi. It is a multi-mode wireless terminal for SOHO (Small Office and...
In such event please restart your device. Getting to Know Your E5 II Packing List The E5 II box contains the following items. If any of the items are lost or damaged, contact your local dealer.
Application Scenarios The Wi-Fi device or computer can be connected to the Internet through the E5 II. The actual connecting procedure depends on the operating system of the Wi-Fi device or computer. You can perform the connection operations as prompted.
Page 4
Game machine Smart phone Laptop Digital camera Scenario 3: Multi-device access via Wi-Fi and USB at the same time...
Page 5
Game machine Smart phone Laptop Digital camera...
Page 7
Appearance Item Screen microSD card slot USB port Power button Wi-Fi/WPS button Dialing button Strap hole Battery button Wi-Fi: Wireless Fidelity WPS: Wi-Fi Protected Setup...
Page 8
Screen Item Signal strength Network Wi-Fi enabled Number of devices connected Internet connection New messages Number of new messages Power level Roaming state M: Manual mode A: Auto mode...
(Wi-Fi key) which is printed on the label next to SIM card slot. Installing the SIM card and the battery Hold the E5 II modem with USB connector facing down and press the top button to remove the back cover and battery and insert the SIM as shown.
To remove the microSD card, open the rubber cap and press the microSD card gently. Do not remove the card when it is being used. Otherwise, the card and the E5 II may be damaged, and the data stored on the card may be...
Charging the Battery Note: If you have not used the E5 II modem for a long time, please charge the battery first. Method 1: By using the power adapter Caution: Use the compatible power adapter priovided inside the box only.
Accessing the Internet through a Wi-Fi Connection Note: Your E5 II modem is preconfigured with Wi-Fi network name (SSID) and password (Wi-Fi key). You can follow the steps below to quickly access the internet. For the details about how to set the parameters, see the Help on the Web management page (http://192.168.1.1)
Page 13
Step3: Access the Internet. 1. Power ON the modem Press and hold to switch ON/OFF the modem. 2. Establish a Wi-Fi Connection (considering Windows XP as an example) Make sure that the Wi-Fi function is enabled. Select Start > Control Panel > Network Connections >...
Page 14
PC must be configured with a wireless network adapter. If Wireless Network Connection is displayed, the wireless network adapter is available. Click View available Wireless Networks to display the wireless network list. Select the Nawras E5832-xxxx from the list and click...
Note: You can find Wi-Fi network name (SSID) and password (Wi-Fi key) on the E5 II exactly below the battery. Wait until the wireless connection icon is displayed in the status area. 3. Access the Internet...
Page 16
Auto. Mode Operations Auto In this mode, E5 II will connect automatically to the Internet when data transmission is requested. If data transmission is not performed over a period of time, the E5 II automatically disconnects from the Internet...
Page 17
Note: You can launch the web management page to select the mode of accessing the Internet. While roaming E5 II automatically disconnects from the established network and then you have to manually connect by pressing and CONNECT holding button.
Accessing the Web Management Page Make sure that the connection between the E5 II and your PC is established either by USB cable or over Wi-Fi. Start the Internet browser and enter http://192.168.1.1 in the address bar. Enter the password, and then click Login.
Page 19
data on the card and share it with the group. Insert the microSD card. Access the web management page. Click SD Card to manage the data stored on the microSD card. You can enjoy the short message (SMS) service on the web management page.
Daily Use Saving Power mode If no operation is performed for a while, E5 II screen will be off. It will go into deep sleep mode if not accessed for 30 minutes. In this state, you can press any key to activate the Wi-Fi function.
Establishing a WPS Connection If the Wi-Fi clients connected to the E5 II support the WPS function, the E5 II can generate a network key without manual input. To establish a WPS connection, please follow the below steps: Power on the E5 II modem.
Example: Wi-Fi Connection to Game Machine (PSP) Turn on the PSP WLAN switch. Select Settings > Network Settings. Select Infrastructure Mode to connect your local Wi-Fi access point. Select New Connection to specify a mnemonic connection name (such as MyE5 II). Select Scan to detect networks in the range.
Page 24
Select the Nawras E5832-xxxx from the list. Then press the > button consecutively to confirm the SSID and input the Wi-Fi key. The default Wi-Fi network (SSID) and password (Wi-Fi key) are attached on the E5 II exactly below the battery.
Enter the password and tap Join. (Networks requiring a password appear with a lock icon.) Note: The Wi-Fi Clients such as iTouch, PS3, and NDS can also access Internet via the E5 II. For details about the operation, follow the user guides of...
Frequently Asked Questions (FAQ) What can I do if the client connected to the E5 II cannot access the Internet? Check and ensure that the client is connected to the E5 II properly. Check the power status to ensure that the E5 II is powered on.
Page 28
What can I do if the client cannot access the WLAN? If there are interferences or shields near the E5 II, you can adjust the position of the E5 II. Check and record the following settings of your Wi-Fi client and E5 II: Wi-Fi network (SSID) and password (Wi-Fi key).
Page 29
Version: V100R001_01 Part Number: 31010EQV...