Wave Home Solutions WV-SCBT Installer Manual page 7

Brick or Concrete Wall: There are two ways of going through
brick. The first method consists of using a hammer drill. Make
holes (approximately 5/8") with the hammer drill 1" apart
through the brick in a circular shape outlining the 6 ¼" hole.
Finish cutting the outer edge of the hole using a chisel. If a
hammer drill is not available, a chisel can be used. As brick is
brittle, chiseling from the center of the pilot hole will chip the
brick easily. Continue chiseling until you reach the outer edge
of the 6 ¼" hole.
MEASURE THE REQUIRED UNIT HEIGHT:
For the Sensor Control BT, which is telescopic, unit must be installed all the way down to
floor level, in order to draw in the moisture. It cannot be higher than 3 inches off floor level.
The Sensor Control BT has an opening at the bottom to allow for additional airflow. This
bottom vent must not be blocked off.
PUT THE UNIT TOGETHER:
Join the two halves (Bottom section must fit inside Top section) of the Sensor Control BT
casing together, overlapping the two pieces so that the desired height is obtained. Remove
screws if necessary. Secure the two halves together using ½" metal fastening screws. Use
cover plate to close gap if necessary. Using aluminum or duct tape seal the seam in the
back where the two halves join together. (If you have a finished ceiling, remove the top
cap so ducting can be passed through ceiling to reach floor joist. This is easily done by
removing the four ½" screws on the side).
B.) Outside the building, find your pilot hole.
Using a hole saw and the pilot hole as a guide,
drill a 6¼" hole at the exterior of the building.
7