Table of Contents
Advertisement
• Make sure that no pipes, studs or wires are in the way.
• Duct has to be dedicated and not combined with any other existing ductwork in operation.
Seal well around the outside opening.
SENSOR CONTROL BT INSTALLATION:
Before installing your Sensor Control BT, make sure that you have the right model and
accessories. For example, a WV-SCBT model is needed for an eight foot high basement.
Make sure that the total length of the unit is taller than your cement wall.
The following items should be included in the accessory box. If parts are missing, contact our
customer service at 1-888-533-1348 EXT 102.
Installer's Manual
Operating Instructions Manual
1 Warranty Card
1 Exhaust Vent – 6"
1 pc. Aluminum tape
TOOLS REQUIRED FOR INSTALLATION:
TOOLS – FOR CONCRETE, CINDERBLOCK OR BRICK INSTALLATION:
Use a hammer drill with chiseling ability ½" x 16" long and
a chisel bit 1" thick.
Hole saw is available from manufacturer.
NOTE:
Grills for replenishment air and interior rooms not included
1 Cover Plate
2 Cable ties
4 Plastic Anchors ¼x1¼"
1 pc vinyl flex 6"x 24"
4 screws # 8 x 2 inch
4 Truss Quadrex screws # 8 x 1¼"
Electric reciprocal or hole saw – 6¼ inch
Drill – ¼" concrete drill bit
Screwdriver – Phillips or Square Head
Measuring tape - Hammer - Pencil
5
1 pipe – 6" x 8"
6 screws # 8 x ½"
.
Hide quick links:
Advertisement
Table of Contents
