Edit Leds; Mute Leds; Meters; Usb - Mackie SP260 Owner's Manual

SP260 2x6 Speaker Processor Features: Front Panel

14. Edit LEDs

two input and six output. Edit LEDs illuminate blue
when engaged. See Mute / Edit Buttons [13].
outside? You know the blue lights lined up on runways?
The color of these Edit LEDs look quite similar to those
of the airport runway's lights.

15. Mute LEDs

two input and six output. Mute LEDs illuminate red
when engaged. See Mute / Edit Buttons [13].

16. Meters

These seven-segment meters display the input and
output signal levels OR the gain reduction amount for
Meter mode. Detailed information may be found on
These meters should remain green with the
occasional bump into the yellow zone. If there is too
much yellow (or any red clipping), lower the mixer's
Main L/R fader until it's gone. You might check the
gain and EQ settings on the SP260 input and output
channels, as well.
when in Level mode.

17. USB

The SP260 may be controlled and programmed
will also find presets for typical Mackie PA system
setups.
computer in order to control all parameters of the
processor via computer.

Factory Reset

It is possible to reset the SP260 2x6 Speaker
Processor to its factory settings.
Please keep in mind that this erases all settings,
including any passwords and presets that may
have been set. Be sure to power down any amps
and/or powered speakers before resetting the SP260.
Please Wait....
Memory Reset
Then you may take your fingers off the buttons.
You will know it worked when the six output
Mute LEDs [15] illuminate after the SP260 is
fully powered up.
Owner's Manual
13