Audio Dubbing - JVC GR-DVX400ED Instructions Manual

70
EN

Audio Dubbing

The audio track can be customised only when
recorded in the 12-bit and SP modes. (
Stereo microphone
Speaker
Remote sensor
Headphone connector
(GR-DVX709 only)
USING THE REMOTE CONTROL UNIT (cont.)
pg. 44)
Open the
connector cover.
A.DUB
PLAY
PAUSE
STOP
1
Play back the tape to locate the point where
editing will start, then press PAUSE (9).
2
While holding A.
DUB (D) on the
remote control, press
PAUSE (9). The
"9D" indicator
appears.
3
Press PLAY (U), then
begin "narrating".
Speak into the
microphone.
To pause dubbing, press PAUSE (9).
4
To end Audio Dubbing, press PAUSE (9), then
STOP (8).
To hear the dubbed sound during playback...
Set "12BIT MODE" to "SOUND 2" or "MIX".
( pg. 38, 51)
NOTES:
Sound is not heard from the speaker during Audio
Dubbing. To hear sound, connect optional
headphones to the headphone connector.
(GR-DVX709 only)
When editing onto a tape that was recorded at
12-bit, the old and new soundtracks are recorded
separately.
If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
If feedback or howling occurs during TV playback,
move the camcorder's microphone away from the
TV, or turn down the TV's volume.
If you change from 12-bit to 16-bit in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-bit recording began.
During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes recorded
in 16-bit audio or a blank portion, Audio Dubbing
stops.
To perform Audio Dubbing while watching on the
television, make connections. (
To perform Audio Dubbing with a video unit
connected to the camcorder's AV connector, first
set "S/AV INPUT" to "ON" in the Menu Screen
(GR-DVX709 only
GR-DVX709 only
pg. 24, 25)
pg. 51).
9D
MIC