JVC GR-DVL145 Instructions Manual page 50

50
EN
SYMPTOM
&
During recording, the date/
time does not appear.
*
Time code does not appear.
(
Images on the LCD monitor
appear dark or whitish.
)
The rear of the LCD monitor
is hot.
q
The indicators and the
image colour on the LCD
monitor are not clear.
w
The LCD monitor or
viewfinder indications blink.
POSSIBLE CAUSES
• "DATE/TIME" is set to "OFF" in the
Menu Screen.
• "TIME CODE" is set to "OFF" in the
Menu Screen.
• In places subject to low tempera-
ture, images become dark due to
the characteristics of the LCD
monitor. When this happens, the
displayed colours differ from those
that are actually recorded. This is
not a defect of the camcorder.
• When the LCD monitor's fluores-
cent light reaches the end of its
service life, images on the LCD
monitor become dark. Consult your
nearest JVC dealer.
• The light used to illuminate the LCD
monitor causes it to become hot.
• This may occur when the surface or
the edge of the LCD monitor is
pressed.
• Certain Fade/Wipe effects, certain
modes of Programme AE with
special effects, "DIS" and other
functions that cannot be used
together are selected at the same
time.
TROUBLESHOOTING
CORRECTIVE ACTION
• Set "DATE/TIME" to "ON" in the
Menu Screen (
• Set "TIME CODE" to "ON" in the
Menu Screen (
• Adjust the brightness and angle of
the LCD monitor (
• Close the LCD monitor to turn it off
or set the Power Switch to "OFF",
and let the unit cool down.
— — — —
• Re-read the sections covering
Fade/Wipe effects, Programme AE
with special effects and "DIS"
( pg. 24 – 27, 33).
(cont.)
pg. 35).
pg. 35, 36).
pg. 15, 16).