Sears 917.60656 Assembly, Operating Instructions And Parts List page 3

FIG. 6
7. Refer to Fig's. 5 and 6. Remove nut, lock-
washer, bushing, flat washer and bolt from
lift link (T). Assemble lift link (T) to cutter
bar lift arm (U) with items previously removed.
8. Remove huglock nut and outer washer from
pin welded to knife head (V). Leave inner
washer on pin. Position end of pitman ass-
embly (W), over pin -- it will be necessary
to have knife assembly in extreme R.Ho pos-
ition. Now slide outer washer, previously re-
moved, over pin and secure with huglock nut.
Assemble the grease fitting (X), shipped in
bag of parts, into positio n shown.
9. Remove cotter pin (Y) from rivet (Z) and re-
move rivet. Attach clevis to foot lift lever as
shown in Fig. 6 with irivet and secure with
cotter Din.
SETTING UP INSTRUCTIONS -- CONTINUED
•
FIG. 4
NOTE: If holes in front frame straps weldment
(P) and tractor mounting bracket (Q), do not al-
ign, it will be necessary to loosen two 7/16
bolts (0) in front frame straps weldment (P) and
frame weldment with bearing cups to line up
holes.
Retighten
7/16 bolts securely.
5. Refer to Fig. 4. Insert remaining bushing
shipped in bag of parts into hole in front
frame straps (P). Secure front frame straps to
tractor mounting bracket (Q) with a 5/8 x 2
finished hex bolt, flat washer 21/32 x 1-5/16
x 13 Ga./ 5/8 lockwasher and hex nut shipped
in bag of parts.
FIG. 5
6. SI ide cutter bar and mounting bracket weldment
;R) into position shown in Fig. 5, beneath yoke
weldment (S). Pins of mounting bracket weld-
ment enter holes in yoke weldment. Secure
with the two cotter pins shipped in bag of
parts.
FIG. 7
_
AA
10. Secure swathboard with plate (AA) attached
to outer runner plate (BB) with a 3/8 x 1
square neck carriage bolt, 3/8 lockwasher
and Gripco lock nut. Bolt, lockwasher and
nut shipped in bag of parts.
NOTE: Tighten Gripco lock nut against lock-
washer tight enough to prevent rattling but loose
enough to permit swathboard to move freely up
and down.
11. Attach swathstick (CC) to swathboard (AA)
with a 3/8 x 1 square neck carriage bolt,
flat washer 7/16 x 1, lockwasher 3/8 and
hex nut. Bolt, washers and nuts shipped in
bag of parts.
NOTE: There are three locations in the swath-
board for the swathstick. For your proper appli-
- 3 —
cation refer to "Swathstick Adjustment.