Table of Contents
Advertisement
Mobility
With LED headlamps, all front lamps are de‐
signed with LED technology or as a light module.
Contact your service center in the event of a
malfunction.
Follow the General instructions on lamps and
bulbs., refer to page
262
Turning lamp on the Xenon headlamp
Follow the General instructions on lamps and
bulbs., refer to page
262
The illustration shows the left side of the engine
compartment.
55-watt bulb, H3
1.
Turn the cap and remove it.
2.
Detach the wire bracket.
3.
Disconnect the cable at the plug-in connec‐
tion and remove the bulb.
4.
Insert the new bulb. Ensure that the bulb has
the correct orientation. Because of its
shape, the bulb can only be inserted in one
direction.
5.
Secure the bulb with the wire bracket.
6.
Connect the bulb.
7.
Mount the cap.
264
Replacing components
Online Edition for Part no. 01 40 2 607 971 - 09 11 490
Tail lamps, bulb replacement
At a glance
1
Turn signal/brake lamp
2
Reversing lamp
3
Inside brake lamp
4
Tail lamp
5
Outside brake lamp
6
Rear reflector
Turn signal, outer brake, tail, and
license plate lamps
Follow the general instructions on lamps and
bulbs, refer to page 262.
These lights are made using LED technology.
Contact your service center in the event of a
malfunction.
Lamps in the trunk lid
Access to the lamps
If necessary, remove the fasteners using the
screwdriver from the onboard vehicle tool kit
and fold away the cover.
Advertisement
Table of Contents
