Tightening Torques - Hitachi SV 12SG Technical Data And Service Manual

(2) Wiring the Stator [22]
When wiring the Stator [22], be sure to insert each terminal in correct direction as shown in Fig. 2. At this
time, securely insert each terminal as far as it will go.
Tab Terminal (Blue) [6]
Internal Wire (Brown) [5]

8-3. Tightening Torques

(1) Tapping Screw (W/Flange) D4 x 20 (Black) [2] ..................... 2.0
(2) Tapping Screws (W/Flange) D4 x 16 [7] [33] ........................ 2.0
(3) Tapping Screw (W/Flange) D4 x 10 (Black) [15] ................... 2.0
(4) Machine Screw M4 x 10 [18] ................................................. 1.8
(5) Seal Lock Flat Hd. Screw M4 x 12 [31] ................................. 1.8
Viewed from the commutator
Fig. 2
--- 7 ---
Internal Wire (Blue) [24]
Tab Terminal (Brown) [23]
0.5 N m (20 5 kgf
•
0.5 N m (20 5 kgf
•
0.5 N m (20 5 kgf
•
0.4 N m (18 4 kgf
•
0.4 N m (18 4 kgf
•
cm, 1.5 0.4 ft-lbs.)
•
cm, 1.5 0.4 ft-lbs.)
•
cm, 1.5 0.4 ft-lbs.)
•
cm, 1.3 0.3 ft-lbs.)
•
cm, 1.3 0.3 ft-lbs.)
•