Bosch GWI 10,8 V-LI Professional Original Instructions Manual page 9

OBJ_BUCH-396-002.book Page 9 Tuesday, January 20, 2009 1:23 PM
Technical Data
Cordless angle drill/driver
Article number
Rated voltage
No-load speed
Max. torque for
hard/soft screwdriving
application according
to ISO 5393
Torque adjustment
range
Max. screw dia.
Max. drilling dia.
– Steel
– Wood
Weight according to
EPTA-Procedure
01/2003
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Assembly
Battery Charging (see figure A)
Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The Li-ion battery is protected against deep dis-
charging by the "Electronic Cell Protection
(ECP)". When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
Bosch Power Tools
chine has been automatically switched off. The
GWI 10,8 V-LI
battery can be damaged.
Professional
To remove the battery 10 press the unlocking
3 601 C60 9..
buttons 9 and pull out the battery downwards.
V= 10.8 Do not exert any force.
-1 The battery is equipped with a NTC temperature
min 0 – 585
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
Nm 13/5
Observe the notes for disposal.
Nm 2.6 – 5.2
Changing the Tool (see figure B)
mm 5
mm 8
mm 10
Inserting
Pull the locking sleeve 1 toward the front and
then push the insert tool to the stop into the
kg 1.1
tool holder 2. The insert tool is automatically
locked.
Removing
Pull the locking sleeve 1 forward and remove the
insert tool.
Dust/Chip Extraction
Do not continue to press the
WARNING
On/Off switch after the ma-
Before any work on the power tool, remove
the battery.
Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
1 609 929 R73 | (20.1.09)
English | 9