JVC GR-AXM700 Instructions Manual page 71

REW
STOP
M–0:12:34
LCD monitor or viewfinder
START/STOP
REW
PLAY
PAUSE
REW
INSERT
RM-V700U
OR
(optional)
COUNTER R/M
PLAY/PAUSE
FF
Page Button
Power Switch
Insert editing
indicator
Tape Counter
System Select
Switch
RM-V705U
(provided)
Insert Editing (Insert A Still Image From
The Built-in Memory Onto A Tape)
You can insert a still image stored in the camcorder's
built-in memory into a previously recorded tape,
replacing a section of the original recording with minimal
picture distortion at the in- and out-points. The original
audio remains unchanged.
Perform steps 1 through 5 in Insert Editing (
before the following procedure.
NOTE:
Use the RM-V705U or RM-V700U remote control unit to
perform this procedure.
SELECT STILL IMAGE
1
First set the System Select Switch to "D.S.C.". Press
the Page Button to select the still image you wish to
insert.
BEGIN INSERT EDITING
2
Press START/STOP. When the counter reaches
"0:00:00", editing stops automatically and the
camcorder enters the Insert-Pause mode.
To insert still images in sequential order onto the
tape . . .
.... press the Page Button to move the page forward.
To insert still images at random onto the tape . . .
.... first record the still image you selected in step 1
onto the tape, then press START/STOP to
engage the Insert-Pause mode. To select another
still image, press the Page Button again, then
press START/STOP. Insert-Editing begins.
END INSERT EDITING
3
Press STOP.
NOTES:
When Insert Editing is performed with the LCD monitor
fully opened, the original audio will be heard from the
speaker.
The tape may stop slightly before or after the
designated end point, and noise bars may appear.
Neither indicates a defect in the unit.
Only video signal is recorded in the Insert Editing
mode.
71
EN
pg. 70)