Martin DMX 5.3 Splitter User Manual page 14

Table 1 shows some pin identification schemes. Consult a qualified
electrician if you have any doubts about proper installation.
Wire
(US system)
black
white
green
Martin RDM 5.5 Splitter
The RDM 5.5 Splitter is supplied with a blue Neutrik PowerCon NAC3FCA
cable-mount connector for power input. The user must supply a suitable
length of power cable that meets the requirements listed on page 5 and
install the PowerCon connector on it as described below. The user must
then either hard-wire the power cable to the building's electrical
installation, providing an easily accessible power on/off switch close to the
device, or install on the power cable a grounding-type (earthed) mains
plug that is suitable for the local power outlets, following the power plug
manufacturer's instructions. Table 1 shows some pin identification
schemes. Consult a qualified electrician if you have any doubts about
proper installation.
Installing a Neutrik NAC3FCA power connector on a power cable
Housing
To install a Neutrik NAC3FCA input
connector on a power cable:
1. Slide the bushing over the cable.
2. Slide the white chuck over cables
3. Prepare the end of the cable by
4. Strip 8 mm (1/3 in.) from the end of each of the wires.
14
Wire
(EU system)
brown
blue
yellow/green
Table 1: Power plug pin identification
Insert
with a diameter (D
(0.2 - 0.4 in.), or the black chuck
over cables with a diameter of 10
- 15 mm (0.4 - 0.6 in.).
stripping 20 mm (0.8 in.) of the cable's outer jacket.
Martin DMX 5.3 and RDM 5.5 Splitters user manual
Pin
live
neutral
ground
) of 5 - 10 mm
a
Marking Screw color
"L" yellow or brass
"N"
or
Chuck
Cable end
silver
green
Bushing