Selecting Call Tone; Using Key Lock; Using The Belt Clip; Using The Wrist Strap - Radio Shack FRS Owner's Manual

Note: The radio continues to scan through channels if
you do not press any buttons.
FRS Frequencies
Channel Frequency
No. (MHz)
1 462.5625
2 462.5875
3 462.6125
4 462.6375
5 462.6625
6 462.6875
7 462.7125

Selecting Call Tone

Press twice. flashes. Then press
MODE
lect one of four different call tones. Press
to standby.

Using Key Lock

8 8 8 8
You can lock ,
MODE
about 1 second to lock or unlock the keys.
when the keys are locked.

Using the Belt Clip

Insert the clip into the socket at the back of the radio until it
clicks. To remove the clip, press the button at the top of
the radio and pull out the clip.

Using the Wrist Strap

You can attach the supplied wrist strap to the radio. Slide
the wrist strap's small loop under the bar at the back of the
radio. You might need to use a small screwdriver or a
straightened paper clip. Then pull the strap's large loop
through the small loop.

CARE

Keep the radio dry; if it gets wet, wipe it dry immediately.
Use and store the radio only in normal temperature envi-
ronments. Handle the radio carefully; do not drop it. Keep
the radio away from dust and dirt, and wipe it with a damp
cloth occasionally to keep it looking new.
Modifying or tampering with the radio's internal compo-
nents can cause a malfunction and might invalidate its
warranty and void your FCC authorization to operate it. If
your radio is not performing as it should, take it to your lo-
cal RadioShack store for assistance.
Channel Frequency
No. (MHz)
8 467.5625
9 467.5875
10 467.6125
11 467.6375
12 467.6625
13 467.6875
14 467.7125
8 8 8 8 9 9 9 9
or
to return
MODE
9 9 9 9
, and . Hold down
MODE
appears

FCC Information

Important: Do not open your radio to make any internal
adjustments. Your radio is set up to transmit a regulated
signal on one of 14 assigned frequencies. It is illegal to al-
ter or adjust the settings inside the radio to exceed those
limitations. Any adjustments to your radio must be made
by a qualified technician using the proper test equipment.
To be safe:
• Never open your radio's case.
• Never change or replace anything in your radio
except the batteries.
Your radio might cause TV or radio interference even
when it is operating properly. To determine whether your
radio is causing the interference, turn it off. If the interfer-
ence goes away, your radio is causing it. Try to eliminate
the interference by:
• moving your radio away from the receiver
to se-
• calling your local RadioShack store for help
If you cannot eliminate the interference, the FCC requires
that you stop using the radio.
This device complies with Part 15 of the FCC Rules . Oper-
ation is subject to the following two conditions: (1) This de-
for
vice may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.

Safety Information

Your wireless handheld portable transceiver contains a
low power transmitter. When the push-to-talk (
is pressed, it sends out radio frequency signals. The de-
vice is authorized to operate at a duty factor not to exceed
fifty percent. In August 1996, the Federal Communications
Commission adopted RF exposure guidelines with safety
levels for handheld wireless devices.
Cautions:
• To maintain compliance with the FCC's RF exposure
guidelines, hold the transmitter and antenna at least 2
inches from your face and speak in a normal voice,
with the antenna pointed up and away from your face.
If you wear the handset on your body while using the
headset accessory, use only the supplied belt clip for
this product and when transmitting, take it out of the
belt to ensure the antenna is at least 1 inch (2.5 cm)
from your body.
• Use only the supplied antenna. Unauthorized anten-
nas, modifications, or attachments could damage the
transmitter and may violate FCC regulations.
3
) button
PTT