Tire Pressure - White Outdoor 760 Operator's Manual

Figure 3-7
WARNING: Before operating this
machine, make sure the seat is engaged
in the seat stop, stand behind the
machine and pull back on seat until fully
engaged into stop.
3. To adjust the position of the seat on models equipped
with a seat adjustment lever, move the seat adjustment
lever (located under the seat) to the left and slide the
seat forward or rearward. See Figure 3-7. Make sure
seat is locked into position before operating the tractor.
Identifying the Mulch Plug
equipped)
On tractor models so equipped, a mulch plug can either
be found within the cutting deck's discharge opening or
packed separately with your unit.
NOTE: Refer to Mulching in the Operation section of this
manual for more detailed information.
If you'd prefer to operate the cutting deck without mulch-
ing, simply remove the mulch plug by unthreading the
plastic wing nut which fastens it to the cutting deck. This
will allow the clippings to discharge out of the discharge
opening during operation. See Figure 3-8.

Tire Pressure

WARNING: Maximum tire pressure un-
der any circumstances is 30 psi. Equal
tire pressure should be maintained at
all times.
The tires on your unit may be over-inflated for shipping
purposes. Reduce the tire pressure before operating
the tractor. Recommended operating tire pressure is
approximately 10 p.s.i for the rear tires & 14 p.s.i. for the
front tires. Check sidewall of tire for maximum p.s.i
Setting the Deck Gauge Wheels
(if so equipped)
Move the tractor on a firm and level surface, preferably
pavement, and proceed as follows
1. Select the height position of the cutting deck by plac-
ing the deck lift lever in the normally desired mowing
height setting (any of the six different cutting height
notches on the right fender).
2. Check the gauge wheels for contact or excessive
clearance with the surface below. The deck gauge
wheels should have between ¼-inch and ½-inch
clearance above the ground as follows:
If the gauge wheels have excessive clearance or
contact with the surface, adjust as follows:
(if so
a. Raise the deck lift handle to its highest setting.
b. Remove the gauge wheels by removing the lock
nuts and shoulder screws which secure them to
the deck. See Fig. 3-9
c. Place the deck lift lever in the desired mowing
height setting.
d. Reinsert the shoulder screw (with each gauge
wheel) into the index hole that leaves approxi-
mately ½-inch between the bottom of the wheel
and the pavement.
Refer to
Leveling the Deck
of this manual for more detailed instructions regarding
various deck adjustments.
11
Figure 3-8
in the Maintenance section
Figure 3-9
3
Setting Up
Your Lawn
Tractor
WARNING
Maximum tire pres-
sure under any
circumstances is 30
psi. Equal tire pressure
should be maintained
at all times.