Tape Length Setting - JVC GR-AX760 Instructions Manual

12
EN
MENU Wheel
Power Switch
Display
REC MODE
S P
E P
E X I T
SP
Display
TAPE LENGTH
T 2 0
T 3 0
T 3 5
T 4 0
E X I T
REC MODE Menu
Recording mode
indicator
TAPE LENGTH
Menu
Tape length
T 3 0
indicator
GETTING STARTED
Recording Mode Setting
Set the tape recording mode depending on your preference.
1
Set the Power Switch to "
comes on.
2
Press the MENU Wheel in. The Menu Screen
appears.
3
Rotate the MENU Wheel to select " TO SYSTEM
MENU" and press it to display SYSTEM MENU.
4
Rotate the MENU Wheel to select "REC MODE" and
press it. The REC MODE Menu appears. Select "SP"
or "EP" by rotating the MENU Wheel and press it.
The Menu Screen reappears with the highlight bar on
" RETURN". Press the MENU Wheel in to close the
Menu Screen.
•"EP" (Extended Play) is more economical, providing
three times the recording time.
NOTE:
If the recording mode is switched during recording, the
playback picture will be blurred at the switching point.

Tape Length Setting

Set the tape length according to the length of the tape
used.
1
Perform steps 1 through 3 above.
2
Rotate the MENU Wheel to select "TAPE LENGTH",
then press it. The TAPE LENGTH Menu appears.
3
Rotate the MENU Wheel to select the correct tape
length setting.
•T20=20 minutes
•T30=30 minutes
•T35=35 minutes
•T40=40 minutes
(in SP)
4
Press the MENU Wheel in. The Menu Screen
reappears with the highlight bar on " RETURN".
Press the MENU Wheel in to close the Menu Screen.
NOTE:
The tape remaining time (
correct tape length has been selected.
(cont.)
". The power lamp
pg. 14) is correct only if the