Montigo PVHFL58-300 Installation & Maintenance Manual

Montigo PVHFL58-300 Installation & Maintenance Manual

5/8 and 5/10 horizontal flush louvered power vent
Hide thumbs Also See for PVHFL58-300:

Advertisement

Quick Links

Installation & Maintenance Manual
WARNING
If the information in these instructions is not followed exactly, a fire or explosion
may result causing property damage, personal injury or death.
NOTICE
PVHEX58-300 power vent is approved for use with Montigo R320, R320-ST, R420,
R420-ST, and RP620.
NOTICE
DANGER
PVVEX58-300 power vent is approved for use with Montigo R320, R320-ST, R420,
Blank
R420-ST, and RP620.
IF YOU SMELL GAS
Blank
Flammable materials
Explosion risk
Toxic
Corrosive
Danger overhead crane
Fork lift trucks
High voltage
Do not try to light any appliance.
Blank
Flammable materials
Explosion risk
Toxic
Corrosive
Danger overhead crane
Fork lift trucks
High voltage
Do not touch any electrical switch; do not use any phone in your building.
General Warning
Laser Radiation
Biohazard
Oxidising
Hot surface
Danger of entrapment
Danger of death
Flammable materials
Explosion risk
Toxic
Corrosive
Danger overhead crane
Fork lift trucks
High voltage
Immediately call your gas supplier from a neighbor's phone. Follow the gas
General Warning
Laser Radiation
Biohazard
Oxidising
Hot surface
Danger of entrapment
Danger of death
Irritant
Slippery floor
Watch your step
Cutting
High temperatures
Glass hazard
Danger of suffocation
Blank
supplier's instructions.
General Warning
Laser Radiation
Biohazard
Oxidising
Hot surface
Danger of entrapment
Danger of death
Irritant
Slippery floor
Watch your step
Cutting
High temperatures
Glass hazard
Danger of suffocation
Gas bottles
Watch for
Electricity
Danger for cutter
Entrapment hazard
Battery hazard
Rotating parts
Flammable materials
Explosion risk
falling objects
Toxic
Corrosive
Danger overhead crane
Fork lift trucks
High voltage
If you cannot reach your gas supplier, call the fire department.
Irritant
Slippery floor
Watch your step
Cutting
High temperatures
Glass hazard
Danger of suffocation
Gas bottles
Watch for
Electricity
Danger for cutter
Entrapment hazard
Battery hazard
Rotating parts
falling objects
Low temperature
Strong magnetic field
Optical radiation
Non ionizing
Radiation
Hazardous to the
Danger of harming
radiation
Environment
your hands
General Warning
Laser Radiation
Biohazard
Oxidising
Hot surface
Danger of entrapment
Danger of death
Gas bottles
Watch for
Electricity
Danger for cutter
Entrapment hazard
Battery hazard
Rotating parts
Low temperature
Strong magnetic field
falling objects
Optical radiation
Non ionizing
Radiation
Hazardous to the
Danger of harming
radiation
Environment
your hands
Irritant
Slippery floor
Watch your step
Cutting
High temperatures
Glass hazard
Danger of suffocation
Low temperature
Strong magnetic field
Optical radiation
Non ionizing
Radiation
Hazardous to the
Danger of harming
radiation
Environment
your hands
NOTICE
Gas bottles
Watch for
Electricity
Danger for cutter
Entrapment hazard
Battery hazard
Rotating parts
falling objects
PVHFL58-300 power vent is approved for use with Montigo R320, R320-ST, R420,
R420-ST, and RP620.
Canadian Heating Products Inc. Langley, BC V4W 4A1 | Montigo Del Ray Corp. Ferndale, WA 98248
XG0519
PVHFL58-300 &
PVHFL510-300
5/8 and 5/10
Horizontal Flush
Louvered
Power Vent
NOTICE
PVHEX510-300 power vent is approved for use with Montigo R520, R520-ST,
R620-ST, R720, and R820.
NOTICE
Installer: Leave this manual with the appliance.
NOTICE
Consumer: Retain this manual for future reference.
PVVEX510-300 power vent is approved for use with Montigo R520, R520-ST,
R620-ST, R720, and R820.
NOTICE
This power vent is approved for use with Montigo fireplaces only and is certified to
ANSI Z21.50 / CSA 2.22 vented gas fireplace standard along with the fireplace.
NOTICE
PVHFL510-300 power vent is approved for use with Montigo R520, R520-ST,
R620-ST, R720, and R820.
070714

Advertisement

Table of Contents
loading

Summary of Contents for Montigo PVHFL58-300

  • Page 1 PVHFL510-300 power vent is approved for use with Montigo R520, R520-ST, R620-ST, R720, and R820. PVHFL58-300 power vent is approved for use with Montigo R320, R320-ST, R420, R420-ST, and RP620. Canadian Heating Products Inc. Langley, BC V4W 4A1 | Montigo Del Ray Corp. Ferndale, WA 98248 XG0519 070714...
  • Page 2: Safety Alert Key

    PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Safety Alert Key Introduction Specifications Pipe Dimensions PVHFL58-300 .... 5"/8" Pipe Dimensions PVHFL510-300 ..5"/10" Maximum Airflow: ......300 CFM Speed: .......... 2700 RPM Power: ..........Connect to fireplace control box ..........Refer to fireplace rating plate...
  • Page 3 " " PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Introduction " " Product Dimensions " 2" " 2" " " " " " Front View " Side View PVHEX10-300 10" PVHEX58-300 8" Back Cover / Collar Outer Assembly 5" " Inner Assembly "...
  • Page 4: Installation

    PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Installation Installing the power vent Step 2: Remove the louver assembly by lifting the bottom end forward and then dropping the door out of the top latches. " Framing Outer Can Assembly " Figure 3a.
  • Page 5 PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Installation Step 4: Slide the inner can out by pulling Step 6: Slide the inner can assembly into the outer can assembly from the inside of the house. Structure Outer Can Assembly Inner Can Assembly...
  • Page 6 PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Installation Step 8: Remove two screws securing electrical plate. Step 11: Attach the power cable from the power vent to the control cable. Figure 3j. Step 12: Push all the excess cable back into the electrical channel of the power vent.
  • Page 7: Wiring Installation

    PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Installation Step 13: Reinstall the door. Tabs Front Grill into the Out Can y by inserting top tabs into the ame and securing the bottom with s provided. Louver Assembly Screw Locations Figure 3l.
  • Page 8 PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Service Power Vent Wiring 6 PIN MOLEX CONNECTOR GREEN BLUE BL CK BROWN BL CK WHITE KEY WAY Figure 4a. Page 8 XG0519 - 070714...
  • Page 9 PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Installation PVHEX58 300 V VENTER TERMINAL X AIR SUPPLY INLET AREA WHERE TERMINAL IS NOT PERMITTED Canadian Installations US Installations Canadian Installations US Installations A= Clearance above grade, veranda, 12 in (30 cm) 12 in (30 cm) J= Clearance to nonmechanical air 6in (15 cm) for appliances <...
  • Page 10 PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Service Servicing Step 4: Remove the three screws securing the rain guard. From the outside of the house Step 1: Turn off gas and power. Step 2: Remove two screws from the bottom of the louver assembly.
  • Page 11 PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Service Reinstalling from the outside Step 1: Reinstall the rain guard using the supplied 3 screws. Figure 6. Step 2: Reinstall door with supplied 2 screws. Tabs Front Grill into the Out Can y by inserting top tabs into the me and securing the bottom with provided.
  • Page 12 PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Service Servicing Step 5: Remove 8 screws securing the inner can assembly to the From the inside of the house ing (from inside) outer can assembly. Step 1: Turn off gas and power. Step 2: Disconnect venting from the power vent...
  • Page 13 PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Service Step 7: Remove the three screws securing the rain guard. Figure 7e. Go to Capacitor or Motor and Capacitor Replacement Section. Page 13 XG0519 - 070714...
  • Page 14 PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Service Reinstalling the inner can Step 3: Secure inner can to the outer can with supplied 8 screws. From the inside of the house Step 1: Screw the rain guard back on with the supplied 3 screws.
  • Page 15: Capacitor Replacement

    PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Service Capacitor Replacement Step 3: Cut fibre white wire from power cable, black wire from capacitor and black wire from motor. REC 1250 Note: Maintenance must be preformed by qualified personnel/ electrician Figure 9.
  • Page 16 PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Service Step 6: Using the large bell connector, connect the black fibre wire from the Step 8: Secure the wiring neatly with the supplied zap straps. Check that the power cable to the black wire from the motor and the black wire from the power vent operates and spins counterclockwise.
  • Page 17 PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Service Step 3: Cut fibre white wire from power cable, black wire from capacitor and Motor and Capacitor Replacement black wire from motor. REC 1251 Note: Maintenance must be preformed by qualified personnel/ electrician Figure 10c.
  • Page 18 PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Service Step 6: Unscrew 8 screws securing the motor mounting plate. Step 9: Secure motor mounting plate with supplied 8 screws & star washers. Figure 10f. Figure 10i. Step 7: Remove the motor. Step 10: Secure new capacitor with supplied screw.
  • Page 19 PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Service Step 12: Using the other supplied large bell connector, connect the white Go to reinstalling either from outside or inside. fibre wire from the power cable to the black wire from the capacitor and the black wire from the motor.
  • Page 20: Appendix A: Warranty

    The duration of any implied warranty with respect to this Montigo Gas Appliance is limited to the duration of the foregoing warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above may not apply to you.
  • Page 21: Appendix B: State Of Massachusetts

    PVHFL58-300 & PVHFL510-300 Horizontal Power Vent Appendix Appendix B: State of Massachusetts Amendment (Gas Fireplace / Equipment sold in the State of Massachusetts) 5.08: Modifications to NFPA-54, Chapter 10 (1) Revise NFPA-54 section 10.5.4.2 by adding a second exception as follows:...
  • Page 22 PVHFL58-300 & PVHFL510-300 Power Vent Termination Ferndale, Washington Langley, British Columbia TF: 1.800.789.6236 TF: 1.800.378.3115 FX: 1.866.3000.0927 FX: 1.604.607.6462 XG0519 - 070714...

This manual is also suitable for:

Pvhfl510-300

Table of Contents