Connect Wires; Mount Into The Dashboard - Philips CE152 User Manual

Connect wires

Note
Make sure that all loose leads are insulated with
electrical tape.
Consult a professional to connect wires as instructed
below.
1
Check the car's wiring carefully and
connect them to the the ISO male
connectors.
ISO male
connectors
a Green strip, black-
edged green strip
b White strip, black-
edged white strip
c Gray strip, black-
edged gray strip
d Purple strip, black-
edged purple strip
e Red strip
f Blue strip
g White-edged blue
strip
h Black strip
i Yellow strip
Connect to
Rear left speaker
Front left speaker
Front right speaker
Rear right speaker
Ignition key +12V DC
when ON/ACC
Motor/electric antenna
relay control lead
control lead
Ground
To the +12V car
battery which is
energized at all times
2
illustrated, if applicable.
L
REAR
R
d c b
Sockets on rear
panel
1 For ISO male
connectors
2 REAR L
REAR R
3
4 ANTENNA
Tip
The pin arrangement for the ISO connectors depends
on the type of your vehicle. To avoid damage to the
unit, connect properly.

Mount into the dashboard

If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
If the car battery is not disconnected, to
avoid short-circuit, make sure that the bare
wires do not touch each other.
a
External sockets or
connectors
As indicated above
Rear left speaker
Rear right speaker
Antenna
EN 7