SD62 Bluetooth Base Station
Model 1022AD01B
For Users in English-Speaking Regions (en)
Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for future
reference.
Users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of accessories
other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may void the
compliance of this product and may result in the loss of the user's authority to operate the equipment.
Cautioin: For power supply, use Intermec Model AE26. No user-serviceable parts.
Radiation Exposure Statement
Warning: This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE C95.1,
Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, Canada RSS-102, and European
Committee for Electrotechnical Standardization (CENELEC) limits for exposure to radio frequency (RF) radiation.
When installing and using this product, a 20 cm (8 in.) passing distance must be maintained from the body or head of the user or nearby
persons and the antenna. The antenna must not be touched during trasmitter operation.
For Users in the U.S.A. and Canada
U.S.A. Digital Emissions Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference received, including interference that can cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the radio or television receiving antenna.
•
Increase the separation between the computer equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
•
•
Consult the dealer or an experienced radio television technician for help.
Canadian Digital Apparatus Compliance
This device complies with Industry Canada license-exempt RSS standards. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference that can cause undesired
operation.
CAN ICES-3 (B)/NMB-3 (B)
For Users in Europe
EU - R&TTE Declaration
Intermec Technologies Corporation declares that this module is in compliance with the essential requirements and other relevant provisions
of R&TTE Directive (1999/5/EC).
•
ETSI EN 300 328
•
ETSI EN 301 489
•
EN 60950-1
•
EN 62311
The transmitter module's output power is 41 mW EIRP. The products using this module are intended for business and industrial
environments.
A copy of the EU Declaration of Conformity is located at: www.intermec.com\support\manuals.
This product is marked with this logo and uses radio frequency bands that are harmonized throughout the European
Community and others as noted in the table below.
1