Mulching The Clippings; Stopping The Engine - Lawn-Boy Insight 10683 Operator's Manual

Figure 21
Note: If the air temperature is below 55°F (13°C),
firmly push the primer in 5 times.
3. Hold the blade control bar against the handle
(Figure 22).
Figure 22
1. Blade control bar
4. Start the engine using the recoil starter (Figure 22).
5. If the mower does not start in 1 or 2 pulls, press the
primer button 1 or 2 times and try starting it again.
Note: If the mower still does not start, contact an
Authorized Service Dealer.

Stopping the Engine

Service Interval: Before each use or daily
To stop the engine, release the blade control bar
(Figure 23).
Important: When you release the blade control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop using
your mower immediately and contact an Authorized
Service Dealer.

Mulching the Clippings

Your mower comes from the factory ready to mulch the
grass and leaf clippings back into the lawn.
If the grass bag is on the mower, remove it (refer to
Removing the Grass Bag) before mulching the clippings.
If the side discharge chute is on the mower, remove it
and lock the side discharge door (refer to Removing the
Side Discharge Chute) before mulching the clippings.
Important: The mower has a safety switch that
prevents you from starting the mower unless you
first install the mulch plug securely on the mower
(Figure 24).
Install the mulch plug as illustrated in Figure 24.
1. Top of mulch plug lever in switch channel
10
Figure 23
Figure 24